Farenheit FHAD-7H Owner's Manual - Connection Diagram
Connect the wires as indicated:
a. Red: Connect to a switched(+) 12 volt source (ACC). Use a lead that has(+) 12V
when the ignition on or in the ACC position so the monitors turns off when the key is
in the off position. Wiring the monitors
“
hot
”
could cause your battery to run down
when the engine is not running.
b. Black: Connect to a good chassis ground.
c. Reversing the polarity of the red and black leads will damage the monitor.
d. Connect the video input connector to the video output from the source unit
(i.e. DVD player)
e. Test the syetem.
VIDEO INPUT
AUDIO INPUT
AUDIO INPUT
VIDEO OUTPUT
AUDIO OUTPUT
AUDIO OUTPUT
File selection and playback
:
Connection Diagram
20
How To Control The Monitor
5
PREV/
9
IR
REMOTE IR SENSOR
MODE
NEXT/
Move to the previous chapter or track
Power
Move to the next chapter or track
1
VOL-/
PLAY/PAUSE
VOL+/
2
3
4
5
6
7
8
9
Monitor on or off.
DVD-AV1-AV2
1.To play a disc ,short press this button if you
wish to pause the playback, short press again
to resume playback when the unit is paused.
2. Long Press this button to display the Setup
menu. The Setup menu enables you to enter
the settings required for the unit to work
properly. In the setup menu, you use /
and select menu. use the to adjust the size
of the value of the select menu, and short press
enter. Long press confirmation press setup
exit.