Farenheit TI-712 Owner's manual - Warning!

Manual is about: Detachable 7” Monitor Touch Screen DVD/CD/MP3/MP4 AM/FM Radio With Bluetooth (only for TI-712B)

Summary of TI-712

  • Page 1

    Ti-712/ ti-712b detachable 7” monitor touch screen dvd/cd/mp3/mp4 am/fm radio with bluetooth (only for ti-712b) owner’s manual take the time to read through this owner’s manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new dvd-receive...

  • Page 2: Warning!

    2 warning! To promote safety, certain functions are disabled unless the parking brake is on. The unit is designed to detect parked status and must be connected to the power supply side of the parking brake switch. Improper connection or use of his connection may violate applicable law and may result...

  • Page 3: Contents

    3 contents warning! ................................................................................................................. 2 operation precautions.................................................................................... 2 accessories................................................

  • Page 4: Accessories

    4 accessories package contains the following accessories for installation and operation of the unit. (1) washer, spring washer, m5 nut 1 each (2) mounting strap 1 (3) bolt 1 (4) screw 4 (5) mounting collar 1 (6) release key 2 (7) screw 1 (8) rubber cushion 1 remote control warranty card user manual ...

  • Page 5

    5 unit installation and removal installation: 1) install the mounting sleeve into the dashboard. 3) slide the unit into the mounting sleeve. 5) install the panel to the unit. 7) press the panel, make sure the gear locked to the mounting hole. 2) bend the tabs into place to secure the sleeve. 4) inst...

  • Page 6

    6 removal: 1) press the button. 3) take faceplate off of the mounting plate. 5) detach the trim bezel. 7) pull the unit out of the mounting sleeve. 2) safely detach the faceplate. 4) take the panel out. 6) insert the keys into the opening between the unit and the mounting sleeve to unlock. 8) illust...

  • Page 7: Wiring Connections

    7 wiring connections note: never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: to watch video the parking wire should be connected t...

  • Page 8

    8 note: - only use groundless loudspeakers. - use only loudspeakers of minimal 40watt, using fewer watts may result in damaging your loudspeakers at higher volumes. - use 4~8 Ω (ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. - do not use 3-cable loudspeakers ...

  • Page 9: Panel

    9 panel 1. Release button press to detach and release the front panel. When the unit was released, it will switch off automatically after a few second. Detach/attach the panel: press rel button and pull out the panel towards yourself to release the panel. To attach it, press the control panel into t...

  • Page 10: Remote Control

    10 6. Home button press it to turn to the main menu quickly. 7. Setup button press it to turn to setting menu quickly. 8. Sel button sel: press it to enter sound setting menu to adjust the sound settings; eq => bass => treble = > balance => fader => eq. Adjust the level by click touch screen to incr...

  • Page 11

    11 2. Power button power on or off 3. Band/ rdm/clear button in radio mode, press it to change radio band in sequence of fm1 → fm2 → fm3 → am1 → am2. In dvd mode, press to play randomly .In bluetooth mode, press briefly it to clear single wrong number. Long press it to clear all the wrong number. 4....

  • Page 12

    12 18. Setup button in dvd mode press it to enter the setup menu. 19. Angle /accept button in dvd mode, press it repeatedly to change the viewing angle (available only with a recorded dvd file or dvd disc that has this function). In bluetooth mode, press to make a call after inputted a phone number ...

  • Page 13: Remove Battery

    13 remove battery note: the distance may vary according to the brightness of ambient light. If the remote is not used for an extended period of time, remove the battery to prevent possible damage from battery leakage and corrosion. Do not place any objects between the remote control unit and the sen...

  • Page 14

    14 ◆ radio player to start radio, tap radio button on main menu screen. Mute the sound.. Increase the volume. Decrease the volume. Touch this button can choose fm1, fm2, fm3, am1, am2. Touch this button can scan the stations from 1-6, long touch it to save the stations with good reception automatica...

  • Page 15

    15 ◆ dvd player to start dvd player, tap on dvd button from main menu screen. Touch screen menu you will not see any buttons while dvd is played. Buttons will appear when you tap on tft screen. Tap the screen again to hide the buttons. Insert dvd disc insert vcd disc note 1. Dvd player will automati...

  • Page 16

    16 ◆disc/usb/sd/mmc interface operation when a file disc, usb or a memory card is played, the screen will show following interface: mute the sound. Stop button. Press it to stop playback from the current track, press it again to final stop to the very beginning play/pause button. Press it to pause t...

  • Page 17

    17 sound control tap sound button to show sound 1 menu. Tap button to show sound 2 menu. Tap button to show sound 3 menu. Eq select eq mode bas level bass up/down tre level treble up/down balance left/right balance control fader front/back fader control beep set keypad sound on /off loudness set lou...

  • Page 18

    18 display control tap display button to show display menu. General control tap general button to show general menu. Radio control tap radio button to show radio menu. Screen screen setting 16:9, 4:3,full backlight backlight setting low, mid, high tilt angle adjust monitor tilt angle clock set clock...

  • Page 19

    19 dvd set up menu tap the dvd button in main menu to enter the dvd player. Press the setup button to enter into the system settings main menu; press the up or down arrow buttons to move to the highlighted menu item and select one of the setup pages: [1]. Subtitle lang setting: with this option you ...

  • Page 20

    20 [7] tv shape: set tft screen mode to the correct ratio: three screen ratio modes are available, normal/ps (4:3 pan scan), normal/lb (4:3 letter box) and wide (16:9). Different disc formats will display different images depending this setting and the screen size used. [8] ntsc/ pal: select this me...

  • Page 21

    21 bluetooth section (only for ti-712b) warning: driving and having a telephone conversation at the same time is dangerous, please park your car before having a telephone conversation. The supplier waves any and all liability when this warning is not followed. To enter bluetooth mode, you can tap bl...

  • Page 22

    22 voice transfer during a call, you can change a call from bluetooth mode to phone by tapping transfer button. To have a call in bluetooth mode again, tap transfer button. Note: the phonebook only supports western characters. Any difference in character will be shown such as “+, * or # ”. 2. Bt pho...

  • Page 23: Smart Control Function

    23 smart control function the smart control is a function to control the iphone which replaces the line-control function of iphone earphone. Use mcu to simulate the iphone earphone line-control function, then send the orders, realize the function of music playback and making or answering phone call ...

  • Page 24: Other Functions

    24 press and hold / or short press button to enter audio control mode. Press any button ( , , / ) to quit this mode. Music mode press or button to play previous / next track. Press and hold or button to fast backward or forward. Press button to play/pause the playback. Phone call mode when a phone c...

  • Page 25: Notes On Disc

    25 notes on disc only use groundless loudspeakers. Use only loudspeakers of minimal 40watt, using fewer watts may result in damaging your loud speakers at higher volumes. Use 4~8 Ω (ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. Do not use 3-cable loudspeaker...

  • Page 26: Troubleshooting

    26 troubleshooting symptom cause remedy fuse is blown replace with fuse of the same amperage. If the fuse blows again, consult your store of purchase power does not turn on. (no sound is produced.) in correct wiring consult your local retailer. No sound output when operating the unit with amplifiers...

  • Page 27: Troubleshooting

    27 troubleshooting symptom cause solution the car ignition is not on. If the power supply is properly connected to the car accessory switch the ignition key to “acc”. No power the fuse is blown. Replace the fuse. Disc cannot be loaded. Presence of disc inside the player remove the disc in the player...

  • Page 28: Technical Specifications

    28 technical specifications general power supply: 11~16v dc current consumption: max. 10 a maximum power output: 52w x 4 channels (max) compatible formats: dvd/svcd/vcd/hdcd/mp3/mp4/video/cdda/picture cdcd-r/-rw/dvd±r/±rw playback dimensions (w x d x h) / weight: 165*178*50 mm/2 kg working temperatu...