Farm&Ranch MH1100-02 Owner's Manual - Team
STEP 4
Attach the rear axle assembly and rear struts to the angled
support brackets using the 10x60mm bolts (2), 10mm lock nuts
(2), and 10mm washers (2).
Attach the rear strut to the base using 10x20mm bolts (2),
10mm lock nuts (2), and 10mm washers (2). Tighten securely.
STEP 6
Install the trailer hitch into the front bracket using a
12x60mm bolt (1), 12mm washer (1), and 12mm lock
nut (1). The bolt should be tight however the trailer
hitch should be able to move up and down freely.
STEP 5
Attach the wheels onto the axles of each of the
front and rear brackets. Place the 20mm
washers (4) onto the axles on the outside of
each wheel. Insert the large cotter pins (4)
through the holes at the end of each axle. Be
sure to bend one side of the cotter pin to keep
it from falling back through the hole in the axle.
TEAM
LIFT
STEP 7
Turn the unit upright onto its wheels for the
remaining steps. Use two people to perform this
step, being careful not to lose control of the cart
while turning it over. The best way to do this is to
flip it over from side to side.