Farmakom GULIVER User Manual - page 14
This part shown in the picture is delivered with
the stove, but unassembled. It is connected by
screws in the manner shown in the picture
(Image 3).
This part should not be used for moving the
stove, because it is not its function and its
handles made of grey cast can be broken.
4 CHIMNEY
Special attention should be drawn to the chimney quality which has to be manufactured according to standards. The
maintenance of the chimney has to be regular. The stove is connected to the chimney through the fitting via appropriate
smoke pipes, in order to provide the adequate tightness and the flow of smoke from the stove to the chimney. The
smoke pipe must not be positioned too deep in the chimney in order not to disturb the draft in the chimney.
Airflow
To ensure adequate stove operation, the draft in the stove chimney flue should be 12±2 Pa. The lower value does not
allow the proper combustion, and as the consequence there is the deposit of carbon and excess quantity of smoke
which goes out through the grilles or the door. If the value of the airflow is too high, the combustion shall be too fast, and
as the result the heat goes out through the chimney. In case of draft greater than 15 Pa, the chimney flue must be fitted
with a damper.
The signs of bad airflow are:
•
Dirty glass, hot handle
•
Smoke enters the room
Glass Care
Caution: Never operate the stove with a broken door glass. Never build the fire up against the glass.
Warning: Do not use any replacement glass other than the original “ceramic” glass manufactured and supplied for use
in this cookstove. Replacement glass is available from manufacturer or authorized dealer. Do not abuse glass door by
striking or slamming it. Never clean hot glass. Never use abrasive cleaner. When necessary, the glass can be cleaned
with low alkaline content commercial stove glass cleaners, which are available from your local dealer.
Glass Replacement Procedure: Insure appliance is not in operation and is thoroughly cooled. Remove screws and
glass clips.Lift glass from glass clips. Replace seal material. Trim to length and butt together. Replace glass into door,
being sure not to over tighten screws and clips.
Oven glass: Replace oven glass only with original “fully tempered soda-lime” glass available from manufacturer or
authorized dealer.