FarmTek OE-24 User Manual - page 3
Printer User's Manual
Page 3
INSTALLING PAPER
1. Unroll several inches of paper.
2. Cut a straight edge on the paper roll if it is jagged. This
will facilitate the entry of the paper into the printer.
3. Slide the paper through the slot connecting the paper
compartment and the printer compartment. You can slide
the paper in about ¼ inch before it stops.
4. While holding the paper in place, press the rocker switch
to the “Paper Feed” position. Continue to hold the switch
in the Paper Feed position until about one inch of paper
has emerged from the top of the printer. (Note: the paper
feeds fairly slow.)
5. Put the paper spindle into the paper roll and press the roll
into the snaps near the back of the printer. Turn the paper
roll to take up any slack in the paper. Make sure the paper
roll can turn freely.
Printer User's Manual
Page 4
INSTALLING PAPER (cont’d)
To Remove the Paper Roll
1. Advance the paper so about one inch of paper is fed out
the top of the printer.
2. Lift the paper roll away from the printer and cut the paper
feeding to the printer with scissors.
3. Pull the remaining paper through the printer. Be sure to
pull the paper through the top of the printer.
WARNING!
Pulling paper out of the back of the printer will
damage the print mechanism.