Faro Droppy-s Instruction Manual - Instruction For Use
Distillatore Droppy-S
7
INSTRUCTION FOR USE
C. To distill water
1. Pull the upper cover from the boiling chamber, allowing for the plug.
2. Pour water into the stainless steel boiling chamber. Make sure not to fill past
the line marked inside the boiling chamber.
3. Place the upper cover on the distiller. Be sure that any spillage outside the
distiller is dried off, and the electrical sockets are dry before plugging the
power cord into the socket on the distiller.
4. Line up the lid with the hole on the collection bottle with the distiller nozzle.
Insert the main power cord into the power socket, and turn the power switch on.
You will hear the fan start to function immediately.
5. The START button on the distiller is set by the factory at “ON” position.
6. For subsequent cycles, please press firmly on the START button when
distillation starts.
7. About an hour after you switch on power, distilled water will begin to drip into
the storage tank.
8. The power supply shall switch off automatically when distillation is completed.
Never remove the upper cover while the distiller is on. Turn off power supply
if wish to stop the distillation process.
MAINTENANCE
- Never se abrasive cleaners or brushes on you distiller
- After each cycle rinse the inside of the boiling chamber with tap water and dry carefully.
Do keep the outside dry.
- To remove the buildup of deposits, follow the instructions on the distiller
cleaning crystals enclosed. Use it once a week or more, depends on the scale
buildup in the boiling chamber.
- If it appears to have a peeling stainless steel, it needs a clean right away.
- The activated charcoal sachet should be replaced once a month or earlier.
- If the condensing coil is clogged with dust, the efficiency of distillation
many be affected. To clean the condensing coil, vacuum the coil regularly
through the slots in the upper cover.