Faro Focus3D X30 Installation Instructions - page 3
2. Unzip the file to your desktop. The .zip file contains two files.
1_firmware.LsSetup
2_firmware.LsSetup
3. Go to
Transfer 1_firmware.LsSetup From the Computer to the Laser Scanner
to continue.
Transfer 1_firmware.LsSetup From the Computer to the Scanner
1. Ensure that your scanner has a fully charged battery, then using the scanner's power supply, plug the scanner into
an electrical power socket. This ensures that if there is a power outage the upgrade will not be interrupted.
2. Take the SD card out of the scanner and put it into your computer.
3. Open the SD card with Windows Explorer. At the top level, there are at least two folders: Preview and Scans. You
may also have an Updates folder. If it exists, delete it. Make sure that you do not use the existing Updates folder.
4. Create a new Updates folder at the top level. Make sure you capitalize the U.
5. Copy the 1_firmware.LsSetup file into the new Updates folder and rename the file to firmware.LsSetup.
6. Remove the SD card from your computer using the Windows safe removal option, and put the SD card into the
scanner.
7. On the scanner, go to Manage > Service > Firmware Update and press the Update button. The update runs,
completing in about 5 to10 minutes. When the screen goes white, the scanner reboots.
8. After the reboot, take SD card out of the scanner and put it into your computer.
9. Go to
Transfer 2_firmware.LsSetup From the Computer to the Focus
3D
to continue.
Transfer 2_firmware.LsSetup From the Computer to the Scanner
1. Open the SD card with Windows File Explorer. Delete the Updates folder from the SD card. Make sure that you do
not use the existing Updates folder
2. Create a new Updates folder at the top level. Make sure you capitalize the U.
3. Copy 2_firmware.LsSetup into the new Updates folder and rename it to firmware.LsSetup..
4. Remove the SD card from your computer using the Windows safe removal option, and put the SD card into the
scanner.
5. On the scanner, go to Manage > Service > Firmware Update and press the Update button. The update runs,
completing in about 45 minutes. When it is finished, the scanner reboots.
6. Go to
Confirm Results
to continue.
Confirm Results
Check that the correct revision number appears.
1. Go to Manage > General Settings > Scanner Details.
2. Check that the Firmware Revision matches the number you wrote down in the
Unzip the Firmware File
section
above.
Your scanner is ready to use.
https://knowledge.faro.com/Hardware/Laser_Scanner/Focus/Firmware_and_Installation_Instructions_for_the_Focus3D_X_30-130-330
Updated: Thu, 23 Mar 2017 05:05:58 GMT
3