Faroudja FPV-1 Installation And Operation Manual - page 4

UNPACKING

Remove the NR Series unit from the shipping con-

tainer and examine it for any signs of shipping

damage or missing items (check inventory list

below). All shipping materials should be saved if

the unit is to be moved or returned for service.

INSTALLATION 

The processor can be either placed on a table or

rack mounted. If the rack mounting installation kit

is used, the rack mount ears are mounted by using

3 screws. It will be necessary to support the rear of

the unit if it will be shipped in the rack by using

rack support rails supplied by the rack manufac-

turer. 

VENTILATION 

The unit uses convection to cool. A fan is not

needed. As hot air raises out of the top vent, cool

air is drawn in from the bottom. These vents must

not be blocked. When rack mounted, a minimum

of 1.75” (1 rack unit height) of free space is

required above and below the unit to allow for

proper cooling. A forced air fan should be added

to the rack installation if power amps are located in

the same air space.

REAR PANEL I/O

Inputs

1. S-Video (4 Pin DIN)

2. Composite Video (BNC)

3. Interlaced Component (480i) or RGBs Video

(BNC)

4. HDTV/Computer (D15M)

10. AC Power

Outputs 

5. RGBH/CV or YPrPb (D15F)

6. RGBH/CV, or YPrPb (BNC)

Note: Both outputs can be used simultaneously

Control 

7. Screen Trigger (12V, 3.5mm, 2 pin, Tip=+ )

8. Remote IR sensor (5V-12V, 3.5mm, Tip=+)

9. RS232 Port (D9F)

2

INSTALLATION

Inventory

1-NR Series Unit

1- Remote + Batteries

1-Owner’s Manual

1- Warranty Card

1- Power Cord

1

2

3

4

5

6

7 8

9

10