Fast Chiller FS3 User Manual - page 6

FAST CHILLER USE

TIME WORKING:

-  On display are two zeros when it is just switched on.

-  Push the button once in order to plan the count (1 minute a time).

-  Hold the button pushed in order to increase the count more quickly.

-  When the button is slacked more than one second, the counts starts.

-  During countdown: if remained time is more than 1 minute, minutes digit flashes on 

display, if it is less than 1 minute seconds digit flashes on display. Hold the button pushed 

for two seconds to stop the count( it gives out a beep).

-  When countdown stopped digits 00 flash on display, acoustic signal starts (10 beeps1at 

a second), digits 00 flash for 44 seconds yet, display goes off.

-  Push once the button to start the countdown again with the regulated time.

-  If the numbers do not appear, replace the clock battery: unplug the power supply of the        

machine, remove the timer from the upper covering, replace the battery on the back 

side, place again the timer and reconnect the machine to the power.

Timer

5

°C

°C

min.