FATMAN ITUBE 452 User Manual - Front & Rear Panel Controls
iTube 452
6
POWER SWITCH - Press this switch to ON for power. The indicator will illuminate while the power is ON.
Press to OFF to switch off the power.
Please Note The Following: Before switching ON the power, be sure to set the volume control to the lowest setting in order to avoid
damage to the speakers - the speaker-protection circuit will mute the volume for a few seconds after power is switched ON.
SOURCE - For selecting the different Signal Source.
VOLUME CONTROL - To increase or decrease the volume.
Front & Rear Panel Controls
Power Switch
Source
Volume
Audio
Signal Input
Speaker
Output
AC Power
Input
Voltage
Switch
Speaker
Output
ATTENTION:
Your iTube 452 should only be
re-started 5 minutes after switching
off, to avoid damaging the tubes.
!
!
452 Manual UK.qxd 3/12/08 12:44 PM Page 6