FatShark RCV922 User Manual

Other manuals for RCV922: User Manual

Summary of RCV922

  • Page 1

    Product warning if you cannot accept the following limitations do not buy this product or return unused immediately: the rcv922ae 2.4ghz headset will accept interferrence from other 2.4 ghz devices. This is not a defect; this is an fcc requirement (part 15) of licence free devices. This product shar...

  • Page 2

    Rcv922 wireless video glasses please read before operating this device congratulations on purchasing the fat shark rcv922 aviator edition wireless video glasses. To ensure your continued enjoyment, please take the time to read through this operating manual before using. Safety precautions: 1. Used t...

  • Page 3

    The charger will automatically stop charging when the battery is fully charged. Do not leave plugged in while unattended. Do not leave battery attached to charger when charger is not plugged in. Headset battery fits into strap. There is a “pocket”sewn into the strap on the right side (next to power ...

  • Page 4

    Headset controls: 4 position mode switch: position 1: off position 2: av out. Wireless operation. Lcd will display transmitted image. Av cable can simultaneously be attached for recording. Position 3: norm. Wireless operation. Lcd will display transmitted image. Av port can also output lcd image (if...

  • Page 5

    Trouble shooting symptom picture not clear white static lines cause channel selection on tx not same as on headset. Another 2.4ghz device is operating nearby objects or people are between you and the tx interference from other 2.4ghz equipment. Solution ensure both tx and headset are on the same cha...

  • Page 6

    Transmitter controls: 2.4ghz 10mw/ 100mw 4 channel switch: note tx shown in ch1 av in: connect to 5p camera molex connector power out: 5v power output as shown on tx label to power camera voltage in: 6.0 - 12v: caution: if using to power a ccd camera, ground test for 1hr before using, some ccd use h...