FAVI 1500 User Manual - page 8
P R O J E C T O R H D
5
composite audio cable to the output of the cable box and the free
end to the red and white inputs on your projector.
• Regular Satellite Box
• Composite Audio/Video – Connect your red, white, and yellow
composite cable to the corresponding outputs on your satellite
box. Then connect the free ends to the corresponding colored
inputs on your projector.
• S-Video – Connect your S-Video cable to the S-Video output on
the satellite box. Then connect the free end of the cable to your
projector S-Video input. Next connect a red and white composite
audio cable to the output of the satellite box and the free ends to
the corresponding composite audio inputs on your projector.
Laptop / PC
• Your VGA cable should first be connected to your PC/Laptop then to your
projector. Please ensure the cable is screwed tightly in place on both ends.
Now set your source button on the projector to PC or VGA. If at this time
you do not see your computer screen projecting you may need to consult your
computer manual for the correct setting. In most cases the correct key
combination to read a VGA signal is function, f4.
Step 2 - Turning on Your Projector
Please first place the projector in the proper viewing position. Next, plug in the
power cord and turn on the main power switch in the rear of the unit. You will
now see the side indicator light blink red. Now, press the top power button.
Please note once you have turned off the unit you should not attempt to turn the
unit back on for 15 minutes. The main power switch should not be turned off
during this cooling period.
Step 3 - Focusing
The image size can only be adjusted by moving the projector. Once you have the
correct image size please gently twist the lens to focus. If the image is distorted
please use the keystone correction wheel located on the bottom of the unit.