FAVI FAVI Fixed Frame Projection Screen User Manual

Page of 4

Download

Bookmark us

1.) Preparing to assemble your screen:

You will need a large floor area to assemble the screen. The floor should be clean

and covered by a soft material such as towels or blankets to keep the screen clean

and prevent damage.

2.) Assembly

Step 2: Select the frame piece that will become the top side of the screen. Insert four of the M5

FAVI Fixed Frame Projection Screen

User Guide

Step 1: Insert the screen tensioners into the frame. The tensioners should be spaced about 8 to

10 inches apart. The number of screen tensioners you have will depend on the size of the screen.

M5 lock nut

lock nuts into the ends of this frame piece with the nylon locking rings facing down towards the front

of the screen frame. Then insert two lock nuts into each side piece that will later join this top piece.

These lock nuts will be used later to attach the mounting brackets to the top corners of the screen.

Page 1
1.) preparing to assemble your screen: you will need a large floor area to assemble the screen. The floor should be clean and covered by a soft material such as towels or blankets to keep the screen clean and prevent damage. 2.) assembly step 2: select the frame piece that will become the top side o...
Page 2
The last section of frame should have two of the corner pieces installed and inserted as shown in the image below. Step 3: insert the four plastic corner pieces into the ends of the frame pieces. Step 4: after the frame corners are installed, use the m3 screws to secure them into place. You should h...
Page 3
Step 6: attach the four supporting rods to the screen tensioners on all four sides of the frame. Step 5: insert the four steel support rods into the sleeves located on the four sides of the screen material. Make sure to insert these carefully so they do not puncture through the sleeves. Step 7: with...
Page 4
3.) installation step 1: install the two corner mounting brackets onto the two top corners of the frame. Use the m5 screws to secure the mounting brackets to the m5 lock nuts you installed earlier. You should have 8 of these screws. Four go in each top corner. (m5 screws) (m5 lock nut) step 2: mount...