Fcoe V-Eyes Instruction Manual - page 8
V.1.02 www.FlyCamOne.com
Preparation
For using the glasses, you additionally need the FCOΞ Core Set as well as the 2.4
or 5.8 GHz FCOΞ Transmission Set.
To control the camera head we developed the FCOΞ LinX System, or for the
usage with your R/C system the FCOΞ RX-cable
For both versions a new basic position of the camera head has to be defined at
first.
Setting of a new basic position of the camera head
Please don´t connect the LinX receiver or the RX-cable yet!
Switch on the camera and set the new basic position by the „
“ buttons of the
FCOΞ logo at the front side of the camera.
If the camera is installed inside the model e.g.,
choose the upright position – 90° of the neutral
position. The new basic position will be confirmed
by pressing the up and down button at once for 5
seconds. Every time the LinX receiver or the RC-
cable will be connected, this new position will be
selected.
confirm
the new
position
Usage of the FCOΞ V-Eyes with the FCOΞ LinX System
The FCOΞ LinX enables the usage of the complete system without a R/C system,
resp. separated from the R/C System.
Schematic View
1. V-Eyes
Glasses
2. V-Eyes
Cable
3. V-Eyes
Base
4. LinX
433MHz
transmitter
5. Transmission
Set
2.4/5.8GHz receiver
6. LinX 433MHz receiver
7. Camera with pivotable
head
8. Transmission
Set
2.4/5.8GHz transmitter