FDS FD101DD-BH Installation And Operation Manual - Specifications
Document Number:
MAN
– FDPWRU28-2
Rev:
C
Revision Date:
08/27/2014
Page 6 of 16
©
2015 Flight Display Systems.
All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FlightDisplay.com
Specifications
Display Type
10.1” TFT Color LCD- Dual
Supported Resolutions
1920x1080i
Native Resolution
1024x600
Display Brightness
300 cd/ m
2
Dimensions (including the ARM)
14.50”(W) x 15.05”(H) x 2.59”(D)
LCD Dimension
9.80”(W) x 12.10”(H)
Weight
5 lbs
Power
12VDC @ .6 Amps
Operating Temperature
0-50° C (32-122° F)
PC & Video Inputs
HD-SDI
Installation Instructions
The FD101DDARM-ML, should be installed on a non-essential bus and have a dedicated
circuit breaker. It is a requirement that a switch be installed in the cockpit so that the pilot
can de-energize the system should it become necessary.
Power
This is a 12VDC monitor that requires 0.6 Amps of power to operate. Power is provided
from the FDCONV-HDSDI-D.
Video Wiring Suggestions
All shields should be floating at the converter and display.
Avoid routing video wiring parallel to:
AC wiring
Strobe wiring
DC motor supply cables
Inverter cabling
Or any other potential noise source.
Power and Ground Wiring
22 AWG wire is recommended for Power and Ground applications.