FDS FD141CV-TS-HDSDI Installation And Operation Manual - Installation Instructions
Document Number:
MAN
– FD141CV-TS-HDSDI
Rev:
D
Revision Date:
01/12/2017
Page 5 of 13
©
2017 FDS Avionics Corp.
All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Installation Instructions
All cabin entertainment equipment, such as the FD141CV-TS-HDSDI, should be installed
on a non-essential bus and have a dedicated circuit breaker. It is a requirement that a
switch be installed in the cockpit so that the pilot can de-energize the entertainment
system should it become necessary.
To install the unit, (4) mounting locations are at the front corners of the unit. Four #10
socket-head screws (not supplied) are needed to secure the unit to the mounting surface.
It is strongly recommended that all four mounting locations be used. When installed, at
least ¼” gap should be maintained along the left and right sides and rear of the unit to
allow for convection cooling.
Power
This is a 28V DC monitor that requires 1.5 AMPS of power to operate. The unit turns on
automatically upon power application.
Wiring Suggestions
All shields should be grounded to the connector at the source, and floating at the display.
Avoid routing video wiring parallel to:
AC wiring
Strobe wiring
DC motor supply cables
Inverter cabling
Or any other potential noise source.