FDS FD171CV-C-4 Installation And Operation Manual - Installation Instructions
Document Number:
MAN
– FD171CV-C-4
Rev:
B
Revision Date:
01/11/2017
Page 4 of 14
©
2017 FDS Avionics Corp.
All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Specifications
Display Type
17.1” TFT Color LCD
Display Color
16.7 Million Colors
Screen Resolution
1440 x 900
Brightness
250 cd/m
2
Dimensions
16.25”(W) x 11.00” (H) x 3.04”(D)
Display Size
14.36”(W) x 8.950”(H)
Weight
8.60 Lb.
Power @ Amp
28V DC @ 2.0A Max. Cont. Steady-
State
Video Type Supported
NTSC/PAL
Video Sources
(4) HD-SDI Quad (In), (1) VGA, (1) S-
Video, (1) Composite, (1) HD-SDI
Loop-Through Driver Output
Screen Control
On Screen Display Menu
Materials
Aluminum
Pixel Pitch
.255 mm X .255 mm
Operating Temperature
0-50° C (32-122° F)
Test Certifications
N/A
Installation Instructions
All cabin equipment, such as the FD171CV-C-4, should be installed on a non-essential bus and
have a dedicated circuit breaker. It is a requirement that a switch be installed in the cockpit so
that the flight crew can de-energize the system should it become necessary.
There are (8) 8-32 UNC mounting holes located on the sides and back of the display. Four
mounting points are located on the rear and two on each side of the bezel. See installation
drawing at end of manual for dimensional details.
Power
This is a
28VDC
monitor that requires 2.0 Amps of maximum continuous steady-state power to
operate. The unit turns on automatically upon power application.