FDS FD600CAM-2 Installation And Operation Manual - Composite Wiring
Document Number:
MAN
– FD600CAM-2 (VER 28V)
Rev:
E
Revision Date:
07/11/2017
Page 5 of 11
©
2017 FDS Avionics Corp.
All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Composite Wiring
Recommended cable for s-video/composite and audio purposes is PIC 75 Ohm Coax,
P/N V76261. This is a lightweight, flexible, and low signal loss cable which meets FAA
flammability requirements of FAR 23.1359(d), FAR 25.853(a) and FAR 25.869(a)(4).
Similar aviation coaxial cable can be used from other vendors, as well.
Some aircraft are
prone to AC noise - we recommend adding to the composite source a 75Ohm video
isolation transformer such as Deerfield Laboratory, Inc. Part No. 162-1
(www.deerfieldlab.com, (650) 632-4090). In most cases this should be added to the video
output of the source.