Summary of FE 100 R/L
Page 2
2 manual magnetic drilling machines 1. Table of contents 2. Table of contents 3. Safety procedures 4. Technical overview 5. Operating manual 5.1 hole cutter selection 5.2 how to mount tools or adapters in a weldon arbor 5.3 drilling with hole cutters 5.4 drilling with twist drills 5.5 tapping / thre...
Page 3
3 manual magnetic drilling machines 1. Safety procedures when using magnetic drilling machines please follow the general safety instructions for electric power tools. Please read the manual use eye protection use ear protection use safety helmet use safety gloves wear appropriate clothing disconnect...
Page 4
4 manual magnetic drilling machines 2. Technical overview fe 30 fe 32 fe 32 r/l fe 36 s fe 50 fe 50 r/l fe 100 r/l motor 800 w 900 w 1050 w 1080 w 1150 w 1150 w 1800 w spindle direct – 19 mm weldon ½”x20 nf – 19 mm weldon ½”x20 nf – 19 mm weldon direct – 19 mm weldon mt 2 – 19 mm weldon mt 2 – 19 mm...
Page 5
5 manual magnetic drilling machines 3. Operating instructions 4.1 hole cutter selection before starting to drill make sure the cutter of your choice is the right one for the job you want to do. Following cutters are available in the fe powertools program:.
Page 6
6 manual magnetic drilling machines 4.2 how to mount tools or adapters in a weldon arbor? 1) make sure the machine is disconnected from the power supply. 2) put the center pilot in the cutter hole. 3) put the cutter or adapter in the arbor, making sure the flat sides are exactly in front of the arbo...
Page 7
7 manual magnetic drilling machines still it is not necessary to use a lot of pressure. Too much pressure will cause damage and breakage. 8 after the cut is finished the slug will automatically be ejected from the cutter, switch the machine off by pushing the red button(0). 9 if the slug gets stuck ...
Page 8
8 manual magnetic drilling machines 7 start bringing the twist drill to the workpiece but handle with care and do not apply too much pressure. The drill has to find its way in to the material by itself. It is not necessary to use a lot of pressure. Too much pressure will cause damage and breakage. 8...
Page 9
9 manual magnetic drilling machines 7 start bringing the tap to the workpiece but handle with care and do not apply pressure. When the tap touches the material it is automatically pulled into the material. After you will have to use minimum pressure to feed the tap. Too much pressure will cause dama...
Page 10
10 manual magnetic drilling machines 4. Tips and tricks tip: do not use your magnetic drill on the same structure when arc welding is in progress. D.C. Current will earth back through the magnet and cause irreparable damage. Tip: when using models with gear and variable speed always select a setting...
Page 11
11 manual magnetic drilling machines 5. Maintenance guidance: check guidance regularly, it may have to be adjusted. Release the counter nuts when dealing with machines with guide beads and tighten the setscrews uniformly. Then retighten the counternuts. Tool holder/arbor: clean the tool holder/arbor...
Page 12
12 manual magnetic drilling machines 7. Warranty the warranty period for fe powertools equipment is 12 months as of the date of purchase. Damages due to wear and tear, overload or improper handling of the machine are excluded from warranty. Damages that are due to fault in material or defect in fabr...