Featuring Controll-A-Door SDO-2V3 Tri-Tran+ Homeowner's Manual - 10. Opener Maintenance
Diamond PD Power Drive : Instruction
Manual
15
Controll-A-Door
®
Prodigy SDO-2V3 Tri-Tran+
TM
Home Owner’s Manual
© Copyright 2014 B&D Doors
10.4 Opener Maintenance
To ensure a long and trouble free life for your
opener the following is recommended:
•
Monthy: Run the Safety Testing procedures in
Section 7 to ensure garage door is fit for use.
NOTE:
If the door does not operate smoothly, call
your nearest Approved Dealer.
10.5 Service Indicator
While the door opener does not require regular
servicing, to function correctly the door must be
in good operating condition. As a reminder the
CAD Prodigy has a built in maintenance counter.
This counter has a factory default of 3000 cycles,
which is the recommended service interval.
When this counter expires the yellow SERVICE
LED will light up and opener beep three times at
the start of each cycle
(Fig. 10.1)
.
In addition the
courtesy light will flash and opener beep five times
at the end of open cycle (when the door is fully
open).
These warning signals will self extinguish after 30
cycles.
When this service counter is triggered it is
strongly recommended you contact your garage
door dealer to arrange a door service
.
See Section
13 for Recommended Service Schedule.
However, if you choose not to have your door
serviced the counter can be reset simply by
pressing the LIMIT SET button.
10.6 Removing the Battery From the
Transmitter
(Battery Type: 3V Lithium Battery CR2032).
Use a non-metallic object (e.g. pen) to remove the
battery.
(Fig. 10.2).
To test the battery is working,
press and hold a transmitter button;
(Fig. 10.3).
Light Status
Battery Status
Solid
OK
Flashing
Requires replacement
No light
Requires replacement
10. Opener Maintenance
Fig. 10.2
BEEP
Fig. 10.1
Fig. 10.3
REPLACE BATTERY WITH CR2032 ONLY
Use a pen
to push the
battery down
through the
side openeing
to release
battery