FED FED 5 Instruction Manual

Summary of FED 5

  • Page 1

    The fed 5 – camera of tomorrow instruction manual by lomography www.Lomography.Com/fed5 the camera of tomorrow...Available today ! A futuristic all-mechanical wonder. Gone is the past of clunky batteries, auto focus, and power film advance. Say goodbye to on-board camera computers, built-in flashes,...

  • Page 2

    Components overview 1. Industrar 61 lens 5. Coupled viewfinder 2. Self timer crank 6. Rangefinder optic 3. Self timer release button 7. Selenium match needle 4. Light meter window 8. Aperture control ring 14. Rewind collar 9. Focus ring 15. Hot shoe 10. Shutter speed dial 16. Dioptric adjustment 11....

  • Page 3

    1. Loading the film to access the film compartment you must remove the one-piece back. It is secured by two rotating latches on the bottom plate. Rotate each latch toward the outside of the camera body and slide the back off. To load film place the 35mm cartridge onto the left spindle, with the film...

  • Page 4

    4. Setting aperture manual aperture controls enable you to select the size of your lens diaphragm opening, across the possible f-stops of f/2.8 (greatest possible aperture), f/4, f/5.8, f/8, f/11, and f/16 (smallest possible aperture). The greater the aperture, the more light is admitted through the...

  • Page 5

    So far, so good? Okay, now, take a look at the inner ring (17) with the asa speeds, and see the numbers on top of it, in a light grey color. These are your aperture values. These will be below the yellow numbers in the outermost ring (yellow and red), which correspond to your shutter speed. You can ...

  • Page 6

    Locate the rewind knob (19) at the top left of the camera. It is a small, rough metal knob. Push it down and turn it counter clockwise until it pops up. Next, press down on the rewind collar (13) as shown above (yes, we think it’s a stupid place to put that as well). It surrounds the shutter release...