Feelworld FPV1032 User manual - page 20
19
enter into the monitor "Function" menu for "Format" option to
select the corresponding standard.
6.2 NO picture after put on the power
Check signal cable contact
①
are in good condition, a monitor is
Synchronized with the input signal, and can press the
"SOURCE/EXIT" give it a try. If in the RF channel, please
Check to see if the transmitter has been work.
②
Check signal cable connecting, and make sure use the standard
adapter connect the monitor. If power supply by battery, please
check the battery whether fully charged.
6.3 Images are not synchronized, DVR can't enter the menu
①
The RF signal is too weak.
②
Find “FUNCTION” in OSD,check if the input video color format
matches accordingly, try other condition.
6.4 Playback the video without sound
① Volume control did not open, try increasing the volume.
② Check if the AUDIO input is workable
6.5 Open the RF, no signal detected
① Transmitter is working properly or not.
② If transmitter frequency matches with the receiver frequency
band
③ If customer change the receiving antenna, please note that must
be matched with the transmitter, otherwise may cause receiving
sensitivity is low, even can't receive signals