Fei Bao Mirage F1 Assembly Manual - Settings.
Channel 1: Ailerons via Power Box 1.
Channel 2: Left Elevator via Power Box 2.
Channel 3: Throttle via receiver to ECU.
Channel 4: Rudder and Nosewheel steering via rx. ch. 4.
Channel 5: Gear via receiver to sequencer.
Channel 6: Flaps via Power Box 5 (Use programmer to
synchronise the flaps.
Channel 7: Right elevator via Power Box 6.
Channel 8: Brakes via Electronic valve.
Settings.
CG: 230mm to 240mm back from where the wing leading edge
meets the fuselage.
Elevator: 60mm up and down. (Measured where the leading
edge of the elevator meets the aft fuselage.)
Ailerons: 20mm down and 25mm up.
Rudder: 30mm left and right.
Flaps: Take off -20mm Landing – 40mm
Scale cockpit installation.
I soon realised that I will not be able to fit the
cockpit tub as one piece so I cut it off with a Dremel to
separate it just behind the instrument panel. I fitted a
balsa “ledge” below the front edge of the windscreen and
the bottom part of the instrument panel is fixed to the
equipment bay with Velcro (hook and loop). The seat area
is cut out once again to leave space for the nose gear
steering servo and the “tub” is fixed with screws to the
cockpit shoulders.
Ground tests.
Check and double check the operation of the landing gear.
Make sure of the nosewheel steering and program in a good
deal of exponential to avoid overactive nosewheel
steering. Check CG in limits and weigh your aircraft for
reference.Check all the flight controls and do not exceed
the recommended settings. Check your turbine for
operation and do not forget the all important range
check. Go over the entire aircraft and make sure every
screw and fitting is tight and threadlocked where needed
(vibration or high stress areas). Check all control
linkages and fittings tight and slop free to avoid
flutter.If the brakes are too tight with the 2 o-rings
per wheel blank off one hole with metal epoxy so that
only one o-ring works as brakes.
This page was created using BCL ALLPDF Converter trial software.
http://store.bcltechnologies.com/productcart/pc/instPrd.asp?idproduct=1