Fein 9-77-25 Operating Instructions Manual
FEIN Turbo Vac III
9-77-25
Operating Instructions
ATTENTION: READ BEFORE USING
MAINTENANCE
After every use:
FEIN Power Tools Inc.
1030 Alcon Street
Pittsburgh, PA 15220
(800) 441-9878
•
Make sure that the voltage nameplate of the device corresponds to the voltage of
your network. The plug has to be protected with a minimum of 20 Amps.
IMPORTANT! THE VACUUM CLEANER IS SUPPLIED FROM THE
FACTORY WITH A SUPPLY CABLE WITH A GROUNDED PLUG. IT
MUST ONLY BE CONNECTED TO AN APPROVED GROUNDED
SOCKET.
•
Before performing any maintenance work, unplug the vacuum from the outlet.
•
WARNING!
EXPLOSION AND FIRE HAZARD!
Never vacuum flammable
fluids or gas, oil, alcohol, solvents, etc. Do not operate near flammable fluids or
gas. Never vacuum warm fluids or materials at more than 140º Fahrenheit
(60º Celsius), such as burning cigarettes, ashes, glowing coals, etc.
•
WARNING!
DO NOT VACUUM HAZARDOUS/CARCINOGENIC DUST
UNLESS THE OPTIONAL HEPA FILTER IS INSTALLED.
•
Do not pull the vac by the cable and do not damage the insulation on the cable.
If the cable is damaged, it must be replaced immediately.
•
Always keep the filter cartridge clean so the vacuum cleaner operates properly.
.
Empty the tank (dirt, dust, and fluids).
.
Never leave fluids in the tank. This could cause damage to the
tank.
.
After vacuuming fluids, it is necessary to dry extension pieces, tube
and motor parts by running the vacuum a few minutes,
after having
emptied the tank.
.
Always keep a reserve of paper dust bags and filter cartridges, so
that the vacuum is always ready for use.
Rev. 6-28-2006