1. DL manuals
  2. FEISHEN
  3. Offroad Vehicle
  4. FA-D50
  5. User Manual

FEISHEN FA-D50 User Manual

Summary of FA-D50

  • Page 1

    User manual read this manual carefully. It contains important safety information. □50 □70 □90 □110

  • Page 2: Introduction

    Introduction this manual will provide you with a clear understanding of the details and operation of this vehicle. This manual includes all of the necessary safety information. It provides information necessary to ride your vehicle and also includes basic service and inspection procedures. An import...

  • Page 3

    Important manual information: failure to follow the warnings contained in this manual can result in serious injury or death. Particularly important information is distinguished in this manual by the following notations: attention: the safety alert symbol means attention! Be alert! Your safety is inv...

  • Page 4

    Important notice this vehicle is designed and manufactured for off-road use only. It is illegal and unsafe to operate this machine on any public street, road or highway. This vehicle complies with all applicable off-road noise level and spark arrester laws and regulations in effect at the time of ma...

  • Page 5

    ! Warning indicates a potential hazard that could result in serious injury or death. Contents: 1 location of the "warning and specification labels"… … … … ....... 1-1 2 safety information........................... 2-1 3 description and machine identification...................................... 3-...

  • Page 6

    Parking...................................................... 6-2 parking on a slope..................................... 6-2 7 periodic service................................. 7-1 engine....................................................... 7-4 engine oil.............................................

  • Page 7

    Location of the "warning and specification labels" read and understand all of the labels on your quad. They contain important information for safe and proper operation of your quad. Never remove any labels from your quad. If a label becomes difficult to read or comes off, a replacement label is avai...

  • Page 8

    ○ 1 ○ 2 ○ 3 ○ 4 1-2.

  • Page 9: Safety Information

    Safety information to drive an atv is a serious matter and can be hazardous to operate. An atv handles differently from other vehicles including motorcycles and cars. A collision or rollover can occur quickly, even during routine maneuvers such as turning and riding on hills or over obstacles, if yo...

  • Page 10

    ●never attempt wheelies, jumps, or other stunts. ●always inspect your atv each time you use it to make sure it is in safe operating condition. ●always follow the inspection and maintenance procedures and schedules described in this manual. ● always keep both hands on the handlebars and both feet on ...

  • Page 11

    Description and machine identification ○ 1 rear rack ○ 2 seat lock ○ 3 seat ○ 4 rear brake pedal (foot operation) ○ 5 main switch ○ 6 handlebar ○ 7 throttle lever ○ 8 speed limiter ○ 9 parking switch ○ 10 front brake lever 3-1.

  • Page 12

    Identification numbers record record the vehicle identification number (vin) and engine i.D. Number in the spaces provided for assistance when ordering spare parts from your dealer or for reference in case the vehicle is stolen. 1. Vehicle identification number the vehicle identification number is s...

  • Page 13: Control Functions

    Control functions main switch functions of the respective switch positions are as follows: on: engine can be started only at this position. Off: all electrical circuits are switched off. The key can be removed in this position. Throttle lever once the engine is running, movement of the throttle leve...

  • Page 14

    Handlebar switches 1. Engine stop switch (red) 2. Start switch 3. Lights switch (black) (option) engine stop switch the engine stop switch controls the ignition and can be used at all times to stop the engine, especially in an emergency. The engine will not start or run when the engine stop switch i...

  • Page 15

    Emergency kill switch this switch is in the front of atv, to which an adult can attach string, and follow the child. If the child needs to stop suddenly, or if the adult wants to stop engine for any reason, just pull the string. 4-3.

  • Page 16

    Front brake lever the brake lever is located on the right side of the handlebar. Pull down on the lever to apply the front brake. Rear brake pedal the brake pedal is located on the right side of the frame. Step on the lever to apply the rear brake. 4-4.

  • Page 17

    Parking brake apply the brake lever and then press down the stop-button to apply the parking brake. Squeeze the rear brake lever to release the parking brake. Speed limiter the speed limiter keeps the throttle from fully opening, even when the throttle lever is pushed to the furthest position. Screw...

  • Page 18

    Seat to remove the seat, pull the seat lock lever upward and pull up the seat at the rear. To install the seat, insert the lobe on the seat front into the receptacle on the frame and push down the seat at the rear. Fuel tank cap remove the fuel tank cap by turning it counterclockwise. Automotive gas...

  • Page 19

    Front shock absorber adjustment the spring preload can be adjusted to suit the vehicle’ s load and riding conditions. Spring preload adjustment: to increase the spring preload, turn the adjuster in direction a. To decrease the spring preload, turn the adjuster in direction b. Standard position: a a-...

  • Page 20: Pre-Operation Checks

    Pre-operation checks before using this atv, check the following points: item routine brakes check operation, free play. Check the combination of the brake lever, brake cable and pad. If the brake pad is becoming worn, please replace with a new one before use of the vehicle. Parking brake check opera...

  • Page 21

    Front and rear brakes 1. Check the operation and free play of the lever. They should move smoothly and there should be a firm feeling when the brakes are applied. If not, have the vehicle inspected by your dealer. 2. Brake operation test the brakes at slow speed after starting to make sure they are ...

  • Page 22

    Engine oil make sure the engine oil is at the specified level. Add oil if necessary. Recommended oil: recommended engine oil classification: api service se, sf, sg type or higher. Attention: do not add any anti-friction modifier to ensure proper clutch function. Oil quantity in engine: 0.9 l (0.24 g...

  • Page 23

    Throttle lever check to see that the throttle lever operates correctly. It must open smoothly and spring back to idle position when released. Repair if necessary for proper operation. Lights if you have installed lights, check the headlight and taillight to make sure they are in working condition. R...

  • Page 24

    2. The tires should be set to the recommended pressure. Recommended tire pressure: front 0.6-0.7 kgf/cm 2 rear 0.7 kgf/cm 2 check and adjust tire pressures when the tires are cold. Tire pressures must be equal on both sides. 3. Tire pressure below the minimum specified could cause the tire to dislod...

  • Page 25: Operation

    Operation warning: to operate atv without being familiar with all controls is extremely dangerous. Freezing control cables in cold weather is extremely dangerous. Make sure everything is working smoothly before starting. To start out and accelerate: 1. Release the parking brake. 2. Open the throttle...

  • Page 26

    Engine break-in attention: the first 20 hrs for engine break-in is very important; never exceed the running condition listed below: 0 ~ 10 hours: avoid continuous operation above half throttle. Allow a cooling off period of five to ten minutes after every hour of operation. Vary the speed of the veh...

  • Page 27: Periodic Service

    Periodic service periodic service/lubrication initial every item routine 1 month 3 months 6 months 6 months 1 year valves check valve clearance. Adjust if necessary. ○ ○ ○ ○ spark plug check condition. Adjust gap and clean. Replace if necessary. ○ ○ ○ ○ ○ air filter clean. Replace if necessary. Ever...

  • Page 28

    Initial every item routine 1 month 3 months 6 months 6 months 1 year fuel line check fuel hose for cracks or damage. Replace if necessary. ○ ○ ○ engine oil check oil level weekly. Replace.(warm up engine before draining.) ○ ○ ○ ○ engine oil strainer clean. ○ ○ ○ brake check operation every time befo...

  • Page 29

    Initial every item routine 1 month 3 months 6 months 6 months 1 year battery check specific gravity. Check that the breather hose is positioned properly. ○ ○ ○ ○ ○ warning: never service the engine while still running! 7-3.

  • Page 30

    Engine spec: 50cc 4 stroke, single cylinder, air-cooled 12v, c.D.I., electric start max power: 2.0kw/7500rpm approx. Max torque: 2.5nm/6000rpm approx. Transmission: auto clutch 70cc 4 stroke, single cylinder, air-cooled 12v, c.D.I., electric start max power: 3.7kw/8500rpm approx. Max torque: 4.5nm/6...

  • Page 31

    Engine oil 1. Engine oil level measurement a. Place the vehicle on a level surface. B. Warm up the engine for several minutes and stop it. C. Wait a few minutes until the oil level settles before checking. D. Remove the dipstick and wipe it off with a clean rag. Insert the dipstick in the filler hol...

  • Page 32

    Idle speed adjustment note: a diagnostic tachometer must be used for this procedure. 1. Start the engine and warm it up for a few minutes at approximately 1,000 to 2,000 r/min. Occasionally rev the engine to 4,000 to 5,000 r/min. The engine is warm when it quickly responds to the throttle. 2. Connec...

  • Page 33

    Brake adjustment – rear brake the rear brake lever free play should be 20~25 mm (0.80~1.0 in.). If the free play is incorrect, adjust it as follows: 1. Raise the rear side of vehicle to make rear tires leave from the ground. 2. Turn the rear wheels and turn the bolts and nuts on these 2 positions to...

  • Page 34

    Fuse replacement if the fuse is blown, turn off the main switch and install a new fuse of the specified amperage. Then turn on the switches. If the fuse immediately blows again, consult your dealer. Specified fuse: 7 a/250 v. 1. Main fuse warning: never use an improper fuse. An improper fuse can cau...

  • Page 35

    Battery asks for replenishment 1. Old style battery will corrode and discharge if not be maintained. The battery fluid should be checked at least once a month. 2. The atv adopts new style battery asking for replenishment. Just enjoy its easy use and sound performance. Replacing the headlight bulb if...

  • Page 36: Specifications

    Specifications model dimensions overall length overall width overall height minimum ground clearance 1420mm 860mm 910mm 160mm basic weight without oil 92 kgs engine engine type displacement starting system lubrication system 4-stroke, single cylinder, air-cooled 50cc 39×41.4mm 70cc 47×41.4mm 90cc 47...

  • Page 37

    Model engine oil type recommended engine oil classification: quantity 0° 10° 30° 50° 70° 90° 100° 130℉ sae 20w40 sae 10w30 sae 5w30 -20° -10° 0° 10° 20° 30° 40° 50℃ api service se, sf, sg type or higher 0.9 l air filter dry element fuel type fuel tank capacity unleaded fuel 3.4 l 8-2.

  • Page 38

    Model chassis frame type steel tube transmission secondary reduction system transmission type automatic tire type size front rear tubeless 160/80-7 160/80-7 brake front brake type operation rear brake type operation drum brake or hydraulic disc brake hand operation hydraulic disc brake foot operatio...

  • Page 39

    Model suspension front suspension rear suspension double swing-arm single swing-arm shock absorber front shock absorber rear shock absorber coil spring/oil damper coil spring/oil damper electrical ignition system generator system battery type/voltage, capacity c.D.I. Magneto 12v, 4a (50/70/90) 12v, ...

  • Page 40: Maintenance Record

    Maintenance record copies of work orders and/or receipts for parts you purchase and install will be required to document maintenance done in accordance with the warranty. The chart below is printed only as a reminder to you that the maintenance work is required. It is not acceptable proof of mainten...

  • Page 41

    Green/yellow g/y black/white b/w blue gray gr bl green g yellow y white w red r brown/white br/w black b colour note horn horn switch br bl bl/y g/y r/b bl/w w y change switch fog light headlight taillight ignition coil foot brake switch ignition starter motor starter magneto annunciator gr g b/w r ...