Feisol CT-3371 User Manual

Page of 4

Download

Bookmark us

WWW.FEISOL.NET

Page 1 of 4

User Manual

►

FEISOL CT-3371 and CT-3471

Mount and Center Column Installation

For exchanging mounts (flat Ball-Head mount / Center Column mount / Leveling Base) on

the tripod, unscrew the three counter-sunk screws on top of the mainframe using the

included Alan key (see picture), insert desired mount and re-tighten the three screws. To

avoid possible damage to the screws or tripod, please do not over-tighten them.

B. Leg Tension Adjustment

Insert the two hexagonal wrenches (included) into the two screws at the base of the leg

(see picture) and tighten or loosen them to the desired friction, by turning the wrenches in

opposite directions.

Page 1
© feisol inc, usa www.Feisol.Net page 1 of 4 user manual ► feisol ct-3371 and ct-3471 a. Mount and center column installation for exchanging mounts (flat ball-head mount / center column mount / leveling base) on the tripod, unscrew the three counter-sunk screws on top of the mainframe using the incl...
Page 2: Www.Feisol.Net
© feisol inc, usa www.Feisol.Net page 2 of 4 c. Leg extension in order to extend a leg section, turn the twist-lock approximately one half turn in counterclockwise direction. Note: if the twistlock is turned too far, the leg section may fall out and compression rings may become lost or damaged. To f...
Page 3: Www.Feisol.Net
© feisol inc, usa www.Feisol.Net page 3 of 4 e. Ball-head (optional) installation when using the flat mounting plate (pre-installed on models ct-3372 and ct-3472), screw the ball-head into the mounting screw by turning the ball-head clockwise until it fits snugly. Please do not over-tighten. When us...
Page 4: Www.Feisol.Net
© feisol inc, usa www.Feisol.Net page 4 of 4 f. Spike (optional) installation remove the rubber caps on the end of the legs by inserting a wooden stick or similar object between the rubber cap and the aluminum ring at the end of each leg (see picture). By pushing forward around the ring, the rubber ...