FeiYu Tech X4 Manual - page 4
Guilin Feiyu Electronics Co., Ltd.
Page | 3
Step 2: Fuselage And Installing The Arms By Solder
Figure 3: Solder (
red arrows
) the 4 arms on to the fuselage plate:
\
1. Note the fuselage plate has a side “A”
and “B”. Ensure side “A” is always
facing upwards.
2. In this step, use the fuselage with
electronics installed. Solder all 4 arms to
this plate (Figure 4).
3. Caution: Do not overheat the arm
contact points, as the metal will deform
make it difficult for plate insertion.
4. Connect 3S Lipo balance plug to the
socket at the bottom of the fuselage; the
LEDs will light up. You may also check with a DC meter at the solder point; it should
indicate approximately 2.3 Volts.
Change any two wire
connection to change
ESC
Fuselage with Electronics
M3×25mm
Pillar
Figure 4