Feiyu tech guilin feiyu electronic technology co., ltd rm. B305, innovation building, information industry park, chaoyang road, qixing district, guilin, cn h p: //www. Fei yu- tech. Com email:feiyudz@yahoo.Cn feiyu y 6 scorpion copter frame instruction manual please read the manual carefully before ...
Feiyu tech guilin feiyu electronic co.,ltd http://www.Feiyu-tech.Com email:feiyudz@yahoo.Cn 1 features 1. Dimensions 2. Empty frame weight: 630g (receiver and battery not included) 3. Payload capability: 900g ( battery, receiver, and camera included) 4. Maximum gross take-off weight: 1430g. Do not o...
Feiyu tech guilin feiyu electronic co.,ltd http://www.Feiyu-tech.Com email:feiyudz@yahoo.Cn 2 install tools needed to build the y6: l soldering iron l rosen core solder l allen wrench (provided) step 1:frame arm assembly note: there are three led on the side of arm,the led should on out side. Unpack...
Feiyu tech guilin feiyu electronic co.,ltd http://www.Feiyu-tech.Com email:feiyudz@yahoo.Cn 3 m3x5mm button head screws. Lay this aside. Take four m3x30 mm pillars, using the allen wrench and m3x5mm button head screw, attach the four pillars to the holes in the side frame. Make sure that the led’s a...
Feiyu tech guilin feiyu electronic co.,ltd http://www.Feiyu-tech.Com email:feiyudz@yahoo.Cn 4 necessary, loosen the screw(s) to properly fit the pieces. Step 3: welding (soldering) the frames to the bottom fuse plate with the electronics. To accomplish this you will need a small soldering iron aprox...
Feiyu tech guilin feiyu electronic co.,ltd http://www.Feiyu-tech.Com email:feiyudz@yahoo.Cn 5 then glow steady. If some of the led’s do not light , inspect all your weld points. You can also take a volt meter and on dc range, check for proper voltage aprox. 2.3vdc is present at the weld points. Once...
Feiyu tech guilin feiyu electronic co.,ltd http://www.Feiyu-tech.Com email:feiyudz@yahoo.Cn 6 propeller installation pay attention to the installation of the propeller direction. End... 2 3 6 5 1 front 4 y6 scorpion flyer 1 (top) = esc 1 cw 2 (top) = esc 2 cw 3 (top) = esc 3 cw 4 (bottom) = esc 4 cc...
