Fellowes Cosmic 125 User Manual - Cold Lamination Steps
1
2
3
4
5
1
2
3
4
5
COLD LAMINATION STEPS
TROUBLESHOOTING
WARRANTY
Fellowes warrants all parts of the laminator to be free of defects in material and workmanship
for 2 years from the date of purchase by the original consumer. If any part is found to be defec-
tive during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases
of abuse, mishandling or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. IN NO EVENT SHALL FELLOWES
BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES ATTRIBUTABLE TO THIS PROD-
UCT. This warranty gives you specific legal rights. You may have other legal rights that vary from
this warranty. The duration, terms and conditions of this warranty are valid world-wide, except
where different limitations, restrictions or conditions may be required by local law. For more
details or to obtain services under this warranty, please contact us or your dealer.
Problem
Ready Light does not go on after extended
time.
Ready Light does not go on for cold
lamination.
Pouch did not completely adhere to item.
Jamming
Cause
Laminator is in a hot, humid area.
If you used the hot lamination setting before a cold lamina-
tion session, the laminator may need time to cool down.
Laminated item may be too thick.
Laminated item was not immediately removed from
machine or small items were laminated without a carrier.
Pouch was not used.
Pouch was not centered or straight when fed through
Pouch/Document Entry.
Solution
Move laminator to a cool dry area.
Wait 90 minutes for laminator to fully cool down.
Pass through laminator a second time.
Press release lever, in back of laminator, to gently pull pouch
out of machine. Use cleaning sheet before laminating.
Always put item in a pouch.
Align sealed edge with Pouch/Document Entry. Use guide
to center.
HOT LAMINATION STEPS
Slide power button to Cold
Setting and wait for green Ready
Light.
To prevent jamming, immediately
remove laminated item from back
of machine.
Place pouch, sealed edge first,
into laminator entry. Keep pouch
straight and use the edge guide
to center it. Continue peeling the
protective sheet away.
Center item on clear side against
sealed edge; documents
cannot
be repositioned once laminated.
• Plug laminator into power
outlet.
• Position laminator so you
have enough space to
allow items to pass freely
through the machine.
Slide power button to Hot
Setting and wait for green
Ready Light.
Place pouch, sealed edge first,
into laminator entry. Keep pouch
straight and use the edge guide
to center it.
To prevent jamming,
immediately
remove laminated item from back
of machine. Let item cool on flat
surface for several seconds.
Before switching off laminator,
feed empty cleaning/carrier sheet
through machine to clean unit.
BEFORE YOU LAMINATE
Use Fellowes
®
brand
pouches for best results.
Select correct pouch size for
laminated item.
Place item inside pouch against
the sealed edge. To prevent
jamming, use a carrier when item
is smaller than the pouch.
CAUTION: Only
use self-adhesive pouches when laminating with a cold setting.
Peel a small part of the protective
sheet away from document.
Need Help?
Customer Service:
US: 1-800-945-4545
Canada: 1-800-665-4339
México: 1-800-234-1185
www.fellowes.com
Let our experts help you with a solution.
Always call us first before contacting your
place of purchase.