Fellowes MS-460Cs Instructions - page 3
Press and hold
Reverse ( )
Set to Off ( )
and unplug.
Set to Off ( )
and unplug.
Press Auto-On ( )
Feed into paper entry
and release
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from
defects in material and workmanship for 7 years from the date of purchase by the original consumer.
Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 2
years from the date of purchase by the original consumer. If any part is found to be defective during the
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and
expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY
LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall
Fellowes be liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid
worldwide, except where different limitations, restrictions, or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Continuous operation:
10-12 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
10-12 minutes will trigger
cool down period to resume
operation.
Pull uncut paper from
paper entry
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
OPERATION
TROUBLESHOOTING
MAINTENANCE
3
Indicator lights:
Follow oiling procedure below and repeat twice.
WARRANTY
Alternate slowly back and forth
Press forward
*Apply oil
across entry
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure bin is pushed in
Wait for motor to cool down
PAPER
CARD/CD/3.5 DISK
Hold card/CD/
3.5 disk at edge
Feed into card/CD/3.5
disk entry and release
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
ATTENTION: If the SafeSense
®
light remains on, you must engage the
Override Switch in order to perform steps above. Once the jam is cleared, reset the
SafeSense
®
feature. (See SafeSense
®
instructions below.)
SafeSense
®
override switch
Active
Not active
Sensor light illuminated–paper jammed
SafeSense
®
paper jam: If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause the user
to think the shredder has jammed when it has not, use the
Override Switch to deactivate the SafeSense
®
feature and clear the paper. Warning – when switch is in override position, the SafeSense
®
light will flash and
the SafeSense
®
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
feature.
Set to Off ( )
and plug in.
Paper jam: Set to Off ( ) and empty bin. Replace bin and follow any or all of the below procedures.
Press and hold
Reverse ( )
Shred one sheet
Press and hold Reverse
( ) 2-3 seconds
10
Disconnect Power Switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.
MS-460Cs_402761_RevC_UK_032008.i5-6 5-6
MS-460Cs_402761_RevC_UK_032008.i5-6 5-6
4/2/08 2:09:34 PM
4/2/08 2:09:34 PM