Fellowes POWERSHRED Shredmate Manual - Basic Product Maintenance
BASIC PRODUCT MAINTENANCE
LIMITED PRODUCT WARRANTY
PAPER/ CARD
Feed into paper
entry and release
Set to Off (OFF)
and plug in
Feed into center of
entry and release
Set to Off (OFF)
Continuous operation:
2-4 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
2-4 minutes will trigger a
15-minute cool down period.
Set to Auto-On
(AUTO)
BASIC SHREDDING OPERATION
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain
service under this warranty, please contact us or your dealer.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Set to Reverse
(REVERSE) 2-3
seconds
* Apply oil
across entry
Set to Off (OFF)
or
TROUBLESHOOTING
Alternate slowly back and forth
Set to Reverse
(REVERSE) for 2-3
seconds
Set to Off (OFF)
and unplug
Gently pull uncut
paper from paper
entry. Plug in.
Set to Reverse
(REVERSE)
1
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
2
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
3
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
4
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
1
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
2
3
4
5
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
1
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
2
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
5
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
6
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
3
AUTO OFF REVERSE
AUTO OFF REVERSE
AUTO OFF REVERSE
PAPER JAM