Felt Edict Nine Manual Manual - page 6
Edict Suspension Manual
Edict Nine Manual
9
10
5. To press fresh DU Bushings into the shock links orient the tools as seen in Fig. 10.
The DU Press (M) should center itself inside the DU Bushing. Tighten the bolt until the
Flange on the DU Press touches the link. Repeat for both left and right links.
6. To reassemble the Dropout Pivot, orient the tools as shown in Fig. 11. Tighten the
screw to press the bearing into the frame. Remember to insert the internal spacer/
sleeve before repeating this step for the second dropout pivot bearing.
7. After making sure that all of the hardware is cleaned of any contaminants, discard
any damaged bearings, spacers, axles or bolts. You are now ready to re-assemble the
frame.
4. To assemble the second bearing in the Seat Tube Pivot, first slip the Link Axle
through the bearing you just installed in step 3, then assemble the tools as shown in
Fig. 9. Tighten the tool assembly using two 5mm Allen/Hex Wrenches, one in each
screw, to draw the second bearing over the axle and into the frame.
3. To install the first new bearing into the Seat Tube Pivot orient the tools as shown in
Fig. 8. Tighten the screw to draw the bearing into one side of the frame.
Alloy Model Instructions
Alloy Model Instructions
H
C I
Q
O
D
C
E
P
R
K
F
F
K
N
A
H
F
K
N
D
Fig. 8
Fig. 9
Fig. 10
Fig. 11