Felt FR SERIES Technical Manual - Routing

CABLE LINER 

INSTALLATION GUIDE

5

4

ROUTING

ROUTING

 FRONT BRAKE

It is best to route the cable from the bottom up. Begin by 

inserting the end of the cable into the lower hole, feeding  

the cable through the fork blade toward the upper hole.

IMPORTANT

To allow for full range of 

handlebar movement, it’s 

important to always route 

the front brake cable on the 

outside of the the cables 

exiting the ports found on 

the headtube. (as shown)

Start by locating the port found on the driveside junction between the seat and the 

chain stay. Thread the cable liner through the port until it exits the port found on the 

bottom bracket. 

Once the cable liner has been properly threaded through the chain stay, you can 

now route the derailleur cable through the liner using a typical cable installation 

procedure.