Istruzioni per l’uso e manutenzione instructions for use and maintenance gebrauchsanleitungen und wartung mode d’emploi et entretien instrucciones para el uso y manutencion/ instruÇÕes de utilizaÇÃo segatrice a nastro band-saw machine bandsÄgemaschine scie a ruban sierra de cinta serra de fita certi...
Dichiarazione di conformitÁ ce del costruttore femi s.P.A. Via del lavoro, 4 - 40023 castel guelfo (bo) - italia tel. +39-0542-670160 - fax +39-0542-670185 - http://www.Femi.It dichiara che la: segatrice a nastro femi 782-783 è conforme alle disposizioni contenute nelle direttive: cee 98/37 - 89/336...
7 en 1 introduction to use before starting work with your sawing machine, carefully read this instructions manual so that you are familiar with the machine and its uses and where it should not be used. Keep this manual in a safe place. It is an integral part of the machine and should be used for ref...
8 en 1.5 safety procedurs for further risk - always keep processing residues away from the cutting area. - always use the clamp. The parts to be cut must always be held firmly in the clamp. - always keep hands away from the working areas while the machine is moving: before loading or unloading the p...
9 en remember that there should be a magnetothermic protective device fitted upstream of the mains to protect all the conductors from short circuits and overloads. This protective device should be selected according to the electrical features of the machine listed below: nominal voltage ...............
10 en after running-in, the same piece may easily be cut in about 2 minutes. If the running-in process is done correctly, the finish and precision of the cut will be of better quality and the blade will last longer. 4.2 working (fig. 7) two speed version push the green button “1” of the main switch ...
11 en electronic version 4.5 correct positioning of the piece in the clamp the pieces to be cut should be fitted directly between the jaws without adding other objects. Attention: never hold the pieces to be cut in your hand. When the pieces to be cut are profiled sections, flat pieces or special sh...
12 en defective motor, power cable or plug. Blown electric panel fuses. No voltage in the mains system. The overload cutout has tripped. Motor overheating. Motor overload caused by excessive cutting pressure. Motor breakdown. The setting of the h and k retainers (point 3.3) is inaccurate. Excessive ...
