Fender Amp Can Reference And Owner's Manual

Summary of Amp Can

  • Page 1

    P/n 050540 rev b reference and owner's manual.

  • Page 2

    Fender musical instruments 7975 north hayden road, scottsdale, arizona 85258 u.S.A. Since 1946, fender realized the importance of your amplifier. You see, your amplifier is more than just a combination of dials, wires and speakers. It is a finely tuned musical instrument. And like any fine musical i...

  • Page 3

    3 constructed from 1/2 inch (1.27 cm) pvc and high- impact abs plastic for long-lasting durability 12v, 4.5 amp hour rechargeable sealed lead acid battery provides 4 to 6 hours of power input channels for guitar, instruments and mic with individual volume and tone controls allowing the input channel...

  • Page 4

    4 a. Guitar input - plug your guitar in here. This is a 1/4 inch, high imped- ance input for electric guitars. B. Guitar vol - adjusts the loud- ness of the guitar input channel. C. Gain - this “push-push” switch selects between low and high gain for the guitar input channel. For high gain, the swit...

  • Page 5

    Your amp can is pow- ered by a 12 volt, 4.5 amp-hour, sealed lead- acid battery. It is very powerful and has much more in common with a car battery than it does a flashlight battery. With proper care and maintenance and under normal oper- ating conditions, the battery could last 3 to 5 years and pro...

  • Page 6

    6 important: do not dispose of the battery in the garbage. For proper disposal of the lead-acid battery, it should be taken to a lead-acid bat- tery recycle and disposal center, such as an automobile service center, to avoid environmental contamination. As a final note, playing your amp can with the...

  • Page 7

    Designation type pr 327 part number 022-1270-000 (100 v) 022-1200-000 (120 v) 022-1230-000 (240 v) aust 022-1240-000 (230 v) uk 022-1260-000 (230 v) euro power output 14.5 w into 4 Ω @ 5%thd with fresh battery input impedance > 1 m Ω both channels input sensitivity 500 µv@ 1 khz - gain switch in gui...