1. DL manuals
  2. Fender
  3. Amplifier
  4. Bassman 500
  5. Owner's Manual

Fender Bassman 500 Owner's Manual

Summary of Bassman 500

  • Page 2

    En gl ish 8 front panel note: the tuner out {s}, power amp in and pre amp out {t} jacks are balanced trs (tip/ring/sleeve) type jacks, with tip=positive (+), ring=negative (–) and sleeve=ground (gnd). While standard shielded ts (tip/sleeve) “mono” guitar cables can certainly be used, the use of “ste...

  • Page 3

    En gl ish 9 rear panel o. Power switch — press to the "on" position to switch the amplifier on. Press to the "off" position to switch the amplifier off. P. Iec power inlet — connect to a grounded outlet in accordance with the input power voltage and frequency specified next to the power inlet on you...

  • Page 4

    En gl ish 10 the bassman® uses the following types of tubes: pre-amplifier: two 12ax7a tubes (v1, v2) v2 (12ax7a) v1 (12ax7a) (chassis, bottom view) if your amplifier is not performing as it should, refer to the troubleshooting section below. Generally speaking with most tube audio amplifiers the tu...

  • Page 5

    En gl ish block diagram 11 specifications model: bassman 500 bassman 800 type: pr 2809 pr 2810 power requirements: 950w 1500w output: 350w into 8Ω 500w into 8Ω 500w into 4Ω 800w into 4Ω input impedances input 1: >820kΩ >820kΩ input 2: 136kΩ (-6db) 136kΩ (-6db) power amp: 20kΩ (balanced) 20kΩ (balanc...

  • Page 6

    Amplificador de audio importado por: fender ventas de méxico, s. De r.L. De c.V. Calle huerta #279, int. A. Col. El naranjo. C.P. 22785. Ensenada, baja california, méxico. Rfc: fvm-140508-ci0 servicio al cliente: 01(800) 7887395, 01(800) 7887396, 01(800) 7889433 a product of: fender musical instrume...