Fender Blues Deluxe Reissue Service Manual - Blues Deluxe™ Reissue
Blues Deluxe™ Reissue
(This is the model name for warranty claims)
4
SERVICE NOTES
1. CHASSIS REMOVAL is accomplished by first
removing two (2) screws from each cabinet side
panel and two (2) screws from the top of the
cabinet. Disconnect the ¼” speaker plug(s)
from the speaker jack(s) and then slide the
chassis toward the rear of the cabinet.
2. BLUES DELUXE REISSUE MAIN PCB RE-
MOVAL is accomplished by removing the
following items: All Vacuum tubes, all knobs in-
cluding washers and nuts (8), four (4) jacks,
nuts and washers. Disconnect the transformer
and primary leads at P1-P12, P15-18. Remove
(1) chassis ground screw, six (6) screws at the
standoffs attached from the bottom of the chas-
sis.
3. BLUES DELUXE REISSUE BREAKAWAY
PCB REMOVAL is accomplished by discon-
necting wires from P13-14 and P19-20 then
removing thirteen (13) screws which attach the
vacuum tube PCB to the chassis from the bot-
tom. Also unsolder gray wire from the external
speaker jack and green wires at pilot lamp.
PCB EXCHANGE POLICY
Parts marked with a single asterisk (
*
) in the Part
Lists are not field replaceable. If a failure due to
one of these components is detected, please
contact the FMIC Customer Service Department to
order the complete PCB Assembly.