Fender Passport PD-250 Instruction Manual

Other manuals for Passport PD-250: Brochure, Service Manual, Instruction Manual
Manual is about: Powered Portable Sound System

Summary of Passport PD-250

  • Page 1

    3 250 watts of clear stereo sound custom designed loudspeakers utilizing the latest in high-performance speaker technology built-in digital reverb vip™ (vocal input priority) allows input one to automatically override all other inputs when a signal is present on input one four mono microphone / line...

  • Page 2

    4 safety precautions the fender passport sound system is supplied with a detachable power cable with an iec female connector and a male ac connector. Depending on the territory in which the passport system is purchased, the power cable will be supplied with one of a number of male ac connectors to a...

  • Page 3

    5 channnels 1 - 4 j. Level – adjusts the volume level of the individual channel. Rotating the knob clockwise increases the respective channel’s contribution to the “main out” mix, while rotating it counterclockwise decreases the volume. Adjust this control after the passport’s master output level vo...

  • Page 4

    6 m. Rev/aux – adjusts the amount of signal sent to the internal reverb processor, and to the rev/aux output jack. In the full left position the control is effectively off. Care should be taken to set the reverb return master control to a middle position or above, before adjusting levels from the in...

  • Page 5

    7 x & z. Stereo inputs – stereo phono (rca) input jacks and 1/4” trs jacks (wired for tip=left, ring=right and sleeve=ground, the standard format of commercially available cables) designed for use with a tape player, cd player, or any other stereo source. Use these jacks for connecting the output of...

  • Page 6

    8 a small storage compartment can be found on the rear of the passport tower. To access this compartment, simply lift the latch and pull open the storage door. This compartment is ideal for storing cables, microphones or other items when you are transporting your passport. On the back panel of the s...

  • Page 7

    9 3. Consider the application and needs of the event and set the system eq control as appropriate. This is best achieved by playing recorded material of the same type as your show program, or by having an assistant speak into the microphone while you listen in the audience area. For public address (...

  • Page 9

    Thank you for selecting the fender passport wireless system. Before installing or operating this system please read this instruction manual thoroughly and familiarize yourself with the system components and correct operating procedures. What is covered in this manual descriptions, installation and u...

  • Page 10

    Belt pack transmitter unit (executive system) the belt pack transmitter has a 4-pin input connector for use with the interchangeable microphones and instrument cable. The microphone and instrument cables have a miniature jack plug. These have threaded collars to assure secure attachment to the trans...

  • Page 11

    A second advantage to this tone key system is that the transmitter can be turned on and off without having to turn off the receiver – or mute its channel on the passport..

  • Page 12: Setting Up

    Setting up unpacking your passport wireless system (or accessory) was packed with care at the factory. The shipping carton was designed to protect it during initial shipment. Please retain this carton in the unlikely event that you need to return your passport wireless for servicing. Remove the dock...

  • Page 13

    Operation once installed, the wireless system is automatically input to channel one of the passport. The wireless systems come with “blanking plugs” (install in the xlr and ¼” jacks for channel one) intended as a reminder that this input is in use. Set-up your passport system as you would for normal...

  • Page 14

    Wireless system specifications carrier vhf 160-250mhz specific freq. Only oscillation mode quartz-controlled channel single receiving mode non-diversity dynamic range >100db squelch tone key squelch controlled circuitry s/n ratio >100db t.H.D. Freq. Response 50hz-18khz +/-3db product specifications ...