Fender Twin Amp 1994 Service Manual - Specifications
’94 TWIN AMP
SPECIFICATIONS
Product Release No.:
PR 266 (This is not a model number)
Part Number:
120V Version :
21-4809
230V Version :
21-4889
Power Requirements:
120V Version: 120 volts AC, 60 HZ, 360 watts.
230V Version: 230 volts AC, 50 HZ, 360 watts.
Input Impedance:
Input 1: 1M
Ω
Input 2: 136k
Ω
Effects Loop:
Pre Reverb.
Nominal Level: +2, -5.5, -13 dbv
Output Impedance: 4.2k
Ω maximum
Input Impedance: 130k
Ω minimum
Effects Mix Control:
Continuously variable between the signal at the
EFFECTS SEND and EFFECTS RETURN jacks.
Reverb:
Post effects loop.
Preamp Out:
Post reverb, +1.3 dbv nominal level.
Recommended load: 22 k
Ω minimum.
Power amp in:
+1.3 dbv sensitivity, 1130k
Ω input impedance.
Balanced Line Output:
Derived from the output transformer, fully balanced.
+3 dbv nominal level into 600
Ω or greater.
Pin 1 floating, pin 2 (+), pin 3 (-)
Amplifier Load Impedance:
Switch selectable for 4, 8, or 16
Ω.
Power Output:
OUTPUT HIGH setting: 100 watts RMS, 5% THD.
OUTPUT LOW setting: 25 watts RMS, 5% THD.
Speaker Complement:
Two Fender P.N 026488 Special Design 12” 8 ohm
speakers wired in series.
Dimensions:
Height:20 3/4”
(52.7 cm)
Width: 26 3/8”
(67 cm)
Depth: 11 1/2”
(29.2 cm)
Weight: 77 lbs.
(35 kg)
Product specifications are subject to change without notice