T h e s o u n d t h a t c r e a t e s l e g e n d s p/n 047775 owner , s manual twin amp type: pr266.
Introduction twin amp sound settings note: these settings are suggested starting points. Your settings may vary due to your guitar, venue, or most importantly...Personal taste! The fender twin™ is the next step up in the evolution of high performance instrument amplification. The new twin is a direc...
Twin front panel functions (fig.1) a. Input 1 — a high impedance, high sensitivity plug-in connection for instruments. B. Input 2 — a plug-in connection for instruments. This input exhibits less input impedance and sensitivity than input 1, making it useful for guitars that have active pickups. This...
If a fuse blows, it should be replaced only with a fuse in accordance with the listing at the fuse holder. If the amplifier repeatedly blows fuses, it should be checked out by a qualified technician. Under no circumstances should a fuse of a different type or higher rating, or a fuse bypass be used,...
L. Output balance adjust — used in conjunction with the bias test points (item k) to set the balance between the push/pull tube sections of the power amp. See output tube bias adjustment instructions below. Output tube bias adjustment instructions — 1. Turn on the amplifier and let it warm up for at...
Of the slave amps such that they never clip with full output from the twin. Here’s why: since the signal at the balanced line out is derived directly from the output transformer, the signal is a replica of the voltage present at the speakers in the twin. If the output of the slave amps never clip, t...
Twin block diagram 1 2 gain 3 2.
A product of: fender musical instruments corp., corona, ca 91720 made in u.S.A. Part number: 120v version: 21-4809 230v version: 21-4889 type: pr 266 dimensions: height: 20-3/4” (52.7 cm) width: 26-3/8” (67 cm) depth: 11-1/2” (29.2 cm) weight: 77 lbs. (35 kg) power requirement: 120v version: 120 vol...
