Www.Feniex.Com e-mail: support@feniex.Com support line: 1.800.615.8350 installation and operational guide feniex avatar series model # l-22109, l-23709, l-24809, l-25709 this instruction manual serves as a guide for the avatar exterior light bar. Important! Please read through all provided instructi...
Safety regulations warranty the following provides all the information necessary to safely operate the previously listed products of feniex industries, inc. Please read this manual thoroughly before installing or operating your new product in order to prevent any damage or injury. Failure to follow ...
The following provides all the information necessary to safely operate the previously listed products of feniex industries, inc. Please read this manual thoroughly before installing or operating your new product in order to prevent any damage or injury. Failure to follow the listed instructions in t...
Avatar lightbar controller function list 12v+ input wire color functions description black mode 1 red mode 2 overrides mode 1 orange mode 3 overrides modes 1 and mode 2 green cruise mode activates all 4 corners at 20% brightness (modes 1, 2 and 3 override this function. Blue takedown steady override...
Wiring diagram www.Feniex.Com ©feniex industries, inc. Wire color functions description black mode 1 red mode 2 overrides mode 1 orange mode 3 overrides modes 1 and mode 2 green cruise mode activates all 4 corners at 20% brightness (modes 1, 2 and 3 override this function. Blue takedown steady overr...
Programming takedowns, alleys or directional enter program mode by connecting the blue/black, the blue/white and the green/white together tap 10 times to 12 v+. Programming front takedowns: connect blue/white to 12 v and connect the required wires to 12vs, tap black/white to lock the selection. Rear...
To service or replace a led module: 1.) remove the top cover by removing the metric m5 phillips screw on the center cover to gain access to the alley or corner modules the aluminum end cap must be removed. To gain access to the end cap, the center top cover must be first removed. 2.) each module is ...
Adjusting height depending on the height of the vehicle, the feet of the bar will need to be adjusted for the required height and angle of the vehicle. To adjust the height: 1.) determine the location for the vehicle for the light bar and check that no equipment will be damaged when drilling holes i...
Warning! Do not overtighten the hex bolts on the light bar. Doing so may cause the light bar to bow downward. Figure d figure f electrical installation power cable wiring: 1.) install a 40amp fuse (customer supplied) to the end of the red, 8 awg wire of the light bar power wire harness assembly. Do ...
Avatar flash pattern list the examples provided illustrate the series of patterns found in the avatar exterior light bar series. Each group shown has 6 different modes of the pattern depicted. Group e: 3-2 pattern • single 50-50 • single 60-40 • single 80-20 • triple 80-20 • accelerator-random • tri...
