Feniex L-4910 Instruction Manual - page 8
V
3.0
TM
FENIEX.
2016
INSTRUCTION MANUAL
WEB.
www.feniex.com
8
Installing Brackets
Hook
Bracket
Hole
Pilot
Holes
Installing a Hook Bracket
Step 1: Remove the 3″ hex bolt from its
packaging and slide the bolt through the
hook bracket hole.
Step 2: Using an open wrench, secure the
hook bracket to the foot bracket hole using
the hex bolt. Repeat on the other side of
the lightbar so both sides have the hook
bracket secured.
Step 3: Place the lightbar with the attached
hook brackets on the vehicle.
Step 4: Secure and tighten the bracket
using an open wrench on each side of the
vehicle until the bar is snugly mounted.
Ensure the vehicle’s door will close without
any interference.
Step 5: Drill and secure the bracket to the
vehicle using the two pilot holes on the
bottom of the hook bracket.
Step 6: Once secure, drill a one inch hole to
route the wire harness through the vehicle
and then seal the hole with a silicone
adhesive.
Important! Use the “Hook Kit Compatibility
Chart” for more information online.
Warning! Utilizing non-factory screws and
mounting brackets may result in loss of
warranty coverage.
Important! Do not overtighten the hex
bolts. Do not exceed 165 in. lb.
Foot
Bracket
Hole
Hook
Bracket
Secure
to vehicle
using
pilot
holes