Fenix 45 Turbo User Manual - 5- Preparation For Use
5- Preparation For Use
•
Remove the machine from the box or the bag.
•
Locate the machine in the horizontal position on a stable surface.
•
Connect the mains plug to outlet.
•
For best performance, place the workpiece to turbo's centre to do operation in
Turbo Mode.
•
Use the largest yoke so that it completely covers the top of both vertical supports.
•
Max Tempereture should be 150 ºC on turbo mode.
Turbo heating
Standard heating
•
For workpieces, that won't fit over the turbo, follow that step:
•
Choose the one of the yokes that fit through the internal diameter of the workpiece
perfectly.
•
Be sure, bright underside of the yoke resting evenly on the two vertical supports of
the machine.
•
If you will use Temperature Mode, be sure that magnet sensor plugged to the
connector. Place the magnet sensor on the inner ring of the bearing or on the
innermost surface of the workpiece. If you will not connect the temperature probe
to connector, you will see “TEMP SENSOR NOT CONNECTED!” message on the
screen after few seconds then the machine will turn back to main menu.
•
If you will use Time Mode, you do not have to connect the magnet sensor to
connector but we highly recommend to connect the temperature probe to check
workpiece's temperature.
•
Turn on the main switch. (For Heater 45 Turbo, Heater 60 Turbo)
WARNING! : Heating high conductivity metals like copper, brass and aluminium on
turbo mode may damage the machine!
CAUTION! : If you will operate Heater 60 and Heater 80 continuously with 20x20mm
and 30x30 mm yokes, operate the machine with 220V voltage supply.
8/16 Feni
X
Induction Heaters