Fenix ATLANTIC F117-D Plug Installation And User Manual - page 9
1.3.2 Wall mounted device
1.3.2.1 Preparation
The wall mounted installation concern all Mechanical devices and Electronic devices.
a.
Release the appliance’s hook-on bracket
(Figure
❻
)
- We recommend that you place the panel heater flat, face down. Have a straight head screwdriver to hand and
lift the tab taking care not deform. While holding the tab rose, push the locking bracket to the bottom of the unit
to release the upper hooks. Rotate the attachment tab around the lower hooks and remove the attachment tab.
b. Fix the hook-on bracket (Figure
❼
)
-
Place the bracket on the ground and against the wall and mark the drilling points
A
. These give the position
of the bottom fasteners. Replace the brackets in alignment with the drilling point
A
to locate drilling points
B
.
These give the position of the upper fasteners. In case of special support, use proper anchors. Position and
screw the wall brackets.
1.3.2.2 Electrical connexion
- The appliance should have a 220 - 230V 50Hz/60Hz power supply.
1.3.2.2.1 Devices without plug :
-
The panel heater must be connected to the mains by a 2-wire cable for Mechanical Device or 3-wire cable for Electronic
Device (Brown= Phase, Blue = Neutral, Black = Pilot wire) by means of a connexion box. In humid areas such as
bathrooms and kitchens the power socket must be installed at least 25 cm above the floor. The installation should be fitted
with a double pole break device with a break of at least 3 mm.
-
Connection to earth is prohibited / Do not connect the pilot wire (black) to earth.
If a driver or driven device is
protected by a 30mA differential (for example for bathroom) it is necessary to protect the power supply of the pilot wire on
that differential.
Commands
Received
Absence de signal
Complete
altermation
U = 220 - 230 V
Negative
Half/altermation
– U/2
Positive
Half/altermation
+ U/2
Oscilloscope
Ref/Neutral
Mode
obtained
CONFORT
ECO
ANTI - FREEZE
STOP HEATING
LOAD SHEDDING
1.3.2.2.2 Devices with plug :
CAUTION
: These devices can not be installed in a fixed position on the French market.
1.3.2.3 Wall mounted installation
(Figure
❽
)
- Place the device inclined on the brackets C and rotates the device to place it on the brackets
D
. Lowering the
device on the bracket. A click indicates that the device is attached and locked. To unlock the attachment tab,
grab a screwdriver and push the tab (at the top left of the attachment tab behind the device) towards the wall.
Lift the device while holding the tab with the screwdriver. Tilt it forward and remove it from the supports
C
.
Neutral = Blue
Phase = Brown
Pilot Wire = Black
Panel heater cable
Phase
Neutral
Electricity
grid
1
st
case: One heater
2
nd
case: Multiple
heater
Unpiloted device
Pilot wire not connected
To devices with reception box
or central programming
2 possible cases: