Lnstruktionsbok clrkelsag manual circular saw bcs-1400 code no. 19694-0407.
36 english original instructions contents 1. Introduction ..........................................36 2. Technical specifications .......................36 3. Product information .............................36 4. Unpacking ............................................37 5 safety instructions .........
37 1. Handgrip 2. Protractor 3. On/off switch 4. Power cord 5. Saw blade safety guard 6. Hexagon screw 7. Soleplate 8. Retaining ring 9. Saw blade 10. Rip fence 11. Rip fence clamping knob 12. Sawing angle clamping knob - shaft locking knob 13. Laser switch 4. Unpacking the circular handsaw is shipp...
38 class ii equipment – double insula- ted – the plug does not have to be earthed. • replacing cables or plugs if the mains cable becomes damaged, it must be replaced with a special mains cable available from the manufacturer or the manufacturer’s customer service. Dispose of old cables or plugs imm...
39 hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur. Investigate and take corrective actions to eliminate the cause of blade binding. • when rest...
40 • never put sideward pressure on the blade. This may cause the blade to break. • be careful when cutting wood with knots, nails or cracks in it and/or dirt on it, as these can cause the blade to get stuck. • never leave the circular saw unattended. 5.6 safety tips for the laser beamer • never loo...
41 • turn the safety guard to the rear, and hold it there with the aid of the knob (11). • withdraw the retaining ring and the saw blade, and clean the saw blade, or replace it with a new one. • again place the saw blade back on the shaft. • allow the safety guard to return over the saw blade by rel...
42 • when cutting it is very diffi - cult to move the work forward in a straight line and the cut is not clean. • the blade is bent or blunt. • replace the blade. • the circular saw makes a lot of noise and/or does not run smoothly. • the carbon brushes are worn. • replace the carbon brushes (fig. 2...
67 bcs - 1400 diagram accessory:.
68 bcs - 1400 part list no. Description specification qty 1 name plate 1 2 head cover body 1 3 hex screw m8 × 16 1 4 big wahser 8 1 5 press plate 1 6 saw blade 1 7 clamping flage 1 8 screw m4 × 10 6 9 flage for lower guard 1 10 lower guard 1 11 screw m4 × 8 1 12 spanner for lower guard 1 13 spring Ø...
)¡ ,-,.,.A..:'l'& tm arete s upplies s.L. Www.Aretesupplies.Co m circular saw bcs-1400
