Summary of BJS-600
Page 1
Manual jig saw instruktionsbok sticksåg bjs - 600 code no. 19694 - 0506.
Page 2: English
41 english original instructions contents 1. Introduction ..........................................41 2. Technical specification .........................41 3. Package contents ..................................41 4. Product information .............................41 5 safetyinstructions ............
Page 3: 5. Safetyinstructions
42 1. Speed control 2. Interlocking knob 3. Switch 4. Connection point vacuum cleaner 5. Allen key 6. Bottom plate 7. Saw buckle 8. Pendulum 9. Guard 10. Saw blade 5. Safetyinstructions in this manual and/or on the machine the fol- lowing symbols are used: in accordance with essential applica- ble s...
Page 4: 6. Assemblyinstructions
43 5.2 using the appliance • clamp the workpiece that you will be sawing in firmly into place. • remove any wood residue that is near or stuck to the surface of the saw blade; do not use your hand for this. Switch the appliance off before removing any residue! • always switch the jigsaw on in idle, ...
Page 5
44 the jigsaw is suitable for all commercially available saw blades. Saw blade type of workpiece coarse wood medium wood fine plastic, aluminium, steel very fine cutting curves (wood) 6.2 assembling saw blade (fig. 2) fig. 2 before assembling the saw blade check that the mains plug has been removed ...
Page 6: 7. Operation
45 7. Operation 7.1 operation b a fig. 4 press the switch in to put the jigsaw into opera- tion. The switch can be interlocked with the interlocking knob. This is done as follows: a. Press the switch in. B. Keep the switch pressed in and press the interlocking knob in. The jigsaw will now continue t...
Page 7
46 7.4 dust-collection (fig.7) fig. 7 to keep the work surface clean, the jigsaw is equipped with a connection for dust extrac- tion. You can connect your vacuum cleaner to this. Use the vacuum cleaner adapter supplied for this. 7.5 guard the jigsaw is fitted with a guard. Make sure that this guard ...
Page 8: 8. Maintenance
47 • put the jigsaw on the rounded front of the bottom plate . • switch on the appliance and slowly lower the jigsaw until it touches the workpiece. • let the jigsaw cut into the workpiece gently without forcing it. • when you are through the workpiece, take the jigsaw out of the hole. • place the a...
Page 9
48 • the appliance runs noisily and/or very unevenly. • the carbon brushes are worn. • contact the service address on the warranty card. • the saw buckle cannot be pushed up to remove the saw blade • the saw blade is stuck • tap gently on the end of the saw blade with a hammer 8.2 cleaning regularly...
Page 10: Bjs - 600 Diagram
73 bjs - 600 diagram.
Page 11: Bjs - 600 Part List
74 bjs - 600 part list no. Description specification qty 1 plastic cover 1 2 pin Ø2 × 18 2 3 plastic shell 1 4 sds spring 2 5 chuck 1 6 pin Ø3 × 12.5 1 7 outer proof ring 2 8 allocation-slide block 2 9 spring 1 10 steel spring 1 11 transparent cover 1 12 reciprocating shaft 1 13 guide bar Ø5 × 61 2 ...
Page 12: Arete S
Arete s upplies s.L. Www.Aretesupplies.Com jig saw bjs - 600