Ferguson RCU640 User Manual - Rcu640
3
ENGLISH
RCU640
Setup TV via manual search
1. Switch on the TV for which you wish to use
the remote control.
2. Point the remote control at the TV. Press
and hold down the TV button. (or just
press TV button for three seconds). Then
release the button.
3. The POWER button lights up and the
remote control is in set-up mode.
4. Press the POWER button approx. every 1.5
seconds. The device should start to flash,
i.e. the device is in Manual Search mode.
5. As soon as the TV switches off (or is reac-
tive), press OK or TV button to save the
codes and exit from Manual Search mode,
now the POWER button light goes off.
6. Check whether the other buttons on the
remote control function correctly. If the
majority of the buttons do not function
correctly, press the POWER button approx.
every 1.5 seconds to initiate the reactive
code (manual search is continued, see
steps 4 to 5).
NOTE:
The Manual Search is automatically
terminated if no entry occurs during a 15
second period.
NOTE:
After entering the state of
setup, ONLY the POWER, OK, LEFT and
RIGHT button, and TV button can work
accordingly, the other buttons did not
have response when you press them.
NOTE:
Entering the manual searching
mode, it will search backward from the
current code backwards, but you can
press LEFT (forward) or RIGHT (backward)
to change Search direction
Display TV Code
You can call up the TV code which you
have set in your new remote control as
follows:
1. Press and hold down the TV button
simultaneously press number button 1
to display the thousands of the 4-digit
code. Count how often the POWER button
flashes. If the POWER button does not
flash, the number is ZERO.
2. Press and hold down the TV button
simultaneously press number button 2 to
display the hundreds of the 4-digit code.
3. Press and hold down the TV button
simultaneously press number btutton 3 to
display the tens of the 4-digit code.
4. Press and hold down the TV button
simultaneously press number button 4 to
display the ones of the 4-digit code.
Example for code 0075:
1. Press TV and 1 LED flashes Zero times.
2. Press TV and 2 LED flashes Zero times.
3. Press TV and 3 LED flashes Seven times.
4. Press TV and 4 LED flashes Five times.
Reset / delete function
1. Press TV button for three seconds the
POWER button on your remote control
lights up.
2. You now have to enter the 4-digit device
code 9990.
All the set-up data and commands for TV
in the remote control are deleted and the
POWER button light goes off.