Ferimex it spol s r.O. Výtvarná 8 bratislava officeba@ferimexit.Sk tel.: +421/2/4564 1701 www.Ferimex.Com outdoor client user’s guide.
Description the outdoor client is an outdoor wireless device used to connect a client to a wireless network. It is designed to operate in outdoor conditions, and has water resistant hou- sing which allows for easy installation on the roof with short cables directly to an exter- nal antenna. A major ...
Led and connectors description act (green) is flashing during wireless traffic. Power (red) is steady when the device is connected to power plug. Link (yellow) is flashing during lan 10baset traffic and steady when the cable is plugged into the ethernet connector rj45. Rj45 connector: to connect the...
Power over ethernet hub lan connection for a lan connection you can use the ethernet card installed in your computer, or a switch (hub). The switch standard you need is 10base-t or 10/100base-t. Cross cab- le is used when the outdoor client is connected directly to an ethernet card in a com- puter. ...
Information you can see the actual configuration and the wireless state. Essid, channel, conne- ction rate, link quality, actual ip address are the most important parameters to check. Wireless settings operating mode infrastructure or ad-hoc mode switch. Information ad-hoc mode. A special mode prima...
The ssid (service set identifier): an important string for network characteristics and identification. This string has to be the same in all devices working in the wire- less channel together. In case the ssid is not specified, the device will connect automatically to whatever access point has the s...
Wep key length encryption quality depends on the wep string length (64bit/128bit). Wep key 1 to key 4 you can choose one of 4 wep keys wep key to use set the key for standard use. Deny non-encrypted data all non-encrypted data will be ignored when you turn on this switch. Shared key authentification...
Default ip address device ip default subnet mask mask default gateway router ip address on network device name not required – name of user or connection name allow upgrade uploads it is possible to change firmware when this parameter is on. Cloning bridge wireless interface has the same mac address ...
Admin menu user name sysop name. Default is administrator administrator password sysop password (only sysop with sysop password can change password next time) reboot bridge device should be rebooted after all changes. This has the same effect as unp- lugging the device from power and plugging it in ...
Technical parameters of ferimex outdoor client: lan port: rj-45 10mbps network interface led: ledx3: ethernet activity, rf activity, power wlan port: n-type female standard: ieee 802.11b dsss, wifi, ethernet 802.3 frequency bands: 2.400 ~ 2.4853 ghz ism band modulation: 1mbps:dbpsk, 2mbps: dqpsk, 5....
Ferimex it spol s r.O. Výtvarná 8 bratislava officeba@ferimexit.Sk www.Ferimex.Com.
