Ferm CDM1096 Original Instructions Manual - 3. Mounting Accessories
EN
6
Ferm
(nails, paper clips, coins, etc.) on the contact
surface of the battery block.
Do not expose the battery block to water or
•
rain.
Only use the battery block supplied in
•
combination with this cordless drill/screwdriver
so as to avoid faults and/or risks to persons.
14. A damaged battery block or one that can no
longer be charged must be disposed of as
special waste. Do not discard it with
household waste.
15. Never throw the battery block onto a fire or
into water. This will risk explosion!
Electrical safety
Always check that the voltage on the
battery block corresponds to the voltage
on the rating plate. Also check that your
mains voltage corresponds to the input
voltage of the battery charger.
Class II machine – Double insulation –
You don’t need any earthed plug.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones.
Remove the battery block when the power tool
•
is not being used and prior to maintenance.
The tool is suitable for use as a screwdriver
•
and drill. Any other application is specifically
excluded.
3. Mounting accessories
Prior to mounting an accessory always
remove the battery.
Fitting and removing drill cutters
Fig. B
In addition to screwdriver bits with a hexagonal
shaft, this tool can also accommodate drill bits with
a hexagonal shaft.
Loosen the drill chuck (3) by rotating the hand-
•
grip (9).
Insert the shaft of the drill cutter into the chuck.
•
Tighten the drill chuck so that the drill cutter is
•
firmly clamped.
Rotate the drill chuck in the opposite direction
•
when you wish to change the cutter.
Connecting and removing the battery
Fig. C
Ensure that the exterior of the battery
block or tool is clean and dry before
connecting the charger.
Ensure that the direction reversing switch (5,
•
Fig. A) is in the central position in order to
prevent the appliance from being switched on
unexpectedly.
Insert the battery (4) into the base of the
•
appliance, as shown on the illustration. Push
the battery until it latches in.
Press the locking buttons (10) on both sides
•
before removing the battery, and disengage
the battery from the base of the appliance.
4. Operation
Always follow the safety notes and the
relevant safety code.
Hold the appliance firmly and press the drill
steadily onto the workpiece. Do not overload the
appliance. Only use drills with no visible wear.
Worn drills will have a bad effect on the functioning
of the appliance.
Adjusting the torque
Fig. D
The appliance has 16 different torque settings with
which to set the power for driving and removing
screws.
Set the torque adjustment ring (2) to the
•
desired position. The available torque settings
are indicated on the adjustment ring by the
numbers 1 to 5 and by dots between the
figures to define intermediate settings (16 in
total).
You should preferably choose a setting as low
•
as possible when using the screwdriver.
Select a higher setting if the motor slips.
Driving and removing screws
Set the direction reversing switch (5) to
•
position ‘L’ in order to drive screws.
Set the direction reversing switch to position
•
‘R’ in order to remove screws.