Page 2 code 975 94, v03_10 technical publication of an informative nature published by fermax electronica s.A.E. As part of its policy of constant improvement, fermax electronica s.A.E. Reserves the right to modify the content of this document and the characteristics of the products referred to in i...
Page 3 introduction .......................................................................................................... 4 features ................................................................................................................ 6 installation .....................................
Page 4.
Page 5 the mds fibre optic (fo) connection allows the transmission of audio, video and data signals from the mds system via fo cables to achieve distances above and beyond those permitted via the electronic cable, in addition providing isolation against noise produced by nearby electrical systems or...
Page 6 features fibre optic. O connector: fc/pc. O fibre: mono mode. O maximum distance: 5km. Video. O connector: bnc 75-5. O video signal:1vpp (75 ohm). O noise signal ratio (nsr) >67db. O bandwidth: 5hz – 10mhz. Data. O connector: 2.5mm, 4 terminal grid. O protocol: rs-485. O speed: o operating mo...
Page 7 size: 132mm × 112mm × 34mm. Power supply: 5.8 vdc, 3a (adaptor included 140 - 260 vac.) important note: two devices cannot be connected in cascade. Installation the fibre optic devices (transmitter/receptor) are powered at 5.8 vdc using adaptors supplied with the equipment. The equipment can ...
Page 8 transmitter tx (1010) power supply (power): 5.8 vdc, 3a (adaptor included 140 - 260 vac.) fibre optic (ftrx). Led signalling: o pwr (power supply): power supply indicator led (yellow). O syn (fibre optic connection status indicator): red indicates incorrect reception. In normal use it should ...
Page 9 rx receptor (1001) power supply (power): 5.8 vdc, 3a (adaptor included 140 - 260 vac.) fibre optic (ftrx). Led signalling: o pwr (power supply): power supply indicator led (yellow). O syn (fibre optic connection status indicator): red indicates incorrect reception. In normal use it should be ...
Page 10 diagrams: 1. Panel bus varistor pc connector conector de pc 12 6 7 8 5 1 2 4 3 lector de proximidad proximity reader key pad terminals conector de teclado amplifier cn2 cn3 cn4 amplificador cn5 descripciÓn description connector conector - +12 ck dt - + a b d c - + sb sa tc cp +12 3 6 2 1 dis...
Page 11 b 2 6 fxl panel 0 2 + - sb sa ct 6 v m a b g a 12vdc ref. 2405 unidad central mds mds central unit decoders d2 d1 + - m v - + g 12 vdc + - d0 1 2 d1 1 2 1 2 d2 3 4 1 2 d3 3 4 d0 1 2 d1 1 2 data rx stairs light relay rele luz de escalera ref. 2013 8 1 + v 3 4 no c nc le + max. 2a 1b. Bus plac...
Page 12 diagrams: 2. Decoder bus b 2 6 fxl panel 0 2 + - sb sa ct 6 v m a b g a 12vdc ref. 2405 unidad central mds mds central unit decoders d2 d1 + - m v - + g 12 vdc + - d0 1 2 d1 1 2 1 2 d2 3 4 1 2 d3 3 4 d0 1 2 d1 1 2 data tx v1 tx rx 5.8 vdc 5.8 vdc b 2 6 fxl panel 0 2 + - sb sa ct 6 v m a b g ...
Page 13 ref.5919 ref.5918 m + m1 ref.5920 v m v v m m v m v ref.5919 + - - + - + - + + - ref. 2419 m5 - bus bus m v 5 1 v - + m - v 8 7 6 video 3 2 4 m + v +- m - v + m v - m7 m6 6 4 3 2 1 6 2 34 1 4 3 6 2 1 6 2 3 1 6 d2 2 d1 + 4 ref.5918 m3 m2 m4 2 telefonos ref. 2425 m5 - 6 2 d2 5 bus pgm 1 bus - ...
Page 14 diagrams: 3. Central unit network (fxl) rx tx 5.8 vdc 18 vdc 12 vdc b 2 6 fxl pa nel 0 2 +- sb sa ct 6 vm ab ga 12vdc ref . 2405 unidad central mds mds central unit decoders d2 d1 + - m v - + g cn1 cn2 cn8 cn7 sa sb ct m v 6 2 - + cn3 sa m ct v sb 6 2 - + cn4 cn5 cn6 out in + - + - sw1 sw2 o...
Page 15 d0 12 d1 12 12 d2 3412 d3 34 d0 12 d1 12 data rx 3b. Red de centrales / central units network b 2 6 fxl panel 0 2 +- sb sa ct 6 vm ab ga 12vdc ref . 2405 unidad central mds mds central unit decoders d2 d1 + - m v - + g malla/ shield a b v1 6 - 2 - coax 3b.
Page 16.
Page 17.
W w w . F e r m a x . C o m ..
